Cavalry EN-CAUH-B Assembly Manual

Thank you for purchasing the CAU

EN-CAUH-B

Enclosure

The CAUH enclosure is elegant, cost-effective, and primarily

designed to protect your Hard Disk from shock. The sleek ABS

plastic enclosure tightly conforms to the shape of your Hard Disk

in order to divert the shock of accidental collisions and direct it

towards the enclosure itself; safely away from the delicate Hard

Disk. This requires a careful assembly process in order to

provide maximum protection to your data. Please read the entire

guide before beginning the assembly!

Note:

*To reduce static discharge, do not

assemble while on a carpeted

surface.

*Handle hard drives on the sides

only. Do not touch any pins or

connectors.

*EN-CAUH-B does not have an

eSATA Connection

1

EN-CAUH-B

Assembly Guide

ENCLOSURETHE EN-CAUH-B ASSEMBLY GUIDE

B

A

2

EN-CAUH-B

Channels

Screwdriver with Philips head

1 SATA hard drive

You will need (not included):

STEP ONE

1

Remove the box contents. Put the two panels off to the side. The

panel with the circuit board will be refered to as Panel A. The lid

will be referred to as Panel B. Take this moment to count all of the

channels on Panel A. Notice that half of them face inwards. Now

count the tabs on Panel B. These are the main mechanisms that hold

Channels

your CAUH together. They must be aligned precisely!

angle, until the data port mates with the

o

Once you have tested your internal hard drive, then we can prepare

to insert it into the enclosure. Turn your 3.5” SATA Hard Disk

upside down, so that it’s circuit board is facing up. Slide it into

STEP TWO

Panel A slowly, at a 45

connector on Panel A.

2