Cavalry CADT001U32, CADT002U32, CADT01AU32, CADT-U32A Series User Manual
User’s Guide: CADT-U32A Series RAID Enclosure
This guide contains instructions for changing the RAID settings on your CADT-U32A Series
Personal Disk Array. If you need assistance, please contact customer service at
customersupport@cavalrystorage.com. The guide is structured as follows:
Product Diagrams - Page 2
RAID Settings Overview with Explanations - Page 3
Instructions for Changing RAID Settings - Page 4
1
Diagrams
Front View:
1. Power indicator
2. Rebuild indicator
3. HDD1 Access Indicator
4. HDD2 Access Indicator
5. HDD1 Error Indicator*
6. HDD2 Error Indicator*
7. Ventilation
*The error LEDs light up when the
corresponding hard drive fails, when
there are rebuilding errors and when the
corresponding hard drive is not present.
Rear View:
1. Power switch
2. Power port
3. USB 2.0 port
4. Fan for ventilation
2
RAID Settings Descriptions
SINGLE MODE Array will show up as two independent drives. This function
can be used if only if two different brands and/or capacities
of HDDs (Hard Disk Drives) are installed.
SPANNING MODE Two HDDs will show up as a single drive with the combined
capacity of both drives. Spanning writes data sequentially
across two drives.
RAID 0 (Striping) Two HDDs will show up as a single drive with the combined
capacity of both drives. Speed and performance increase.
The two HDDs “stripe" data across the two drives. This splits
each piece of Data across both HDDs in segments in a way
that speeds up reading and writing times. However, RAID 0
does not offer any data protection: if one drive fails or is
damaged, all data can be lost.
RAID 1 (Mirroring) The RAID controller creates an extra copy (or mirror) of data
on the two drives. Only a single drive will show up on your
computer, and it will have the capacity of a sing le drive.
Data is protected from the failure of one drive. If one drive
fails, replace it with an identical drive and the data rebuilds
automatically.
Using this mode requires 2 identical HDDs; the two drives
must be the same capacity, brand and model number.
3
Changing RAID Settings
1. Start your computer and wait for your operating system to load completely.
2. Connect the square end of the USB 2.0 cable to your CADT-U32 disk array. Connect
the flat end of the USB 2.0 cable to your computer.
3. Connect the power cable to your CADT-U32 disk array. Connect the other end of the
power cable to an electrical outlet.
4. Turn on the drive.
5. You will need to un-initialize the drive befo re changing RAID settings. To do this,
follow the instructions for your Operating System below. (Mac OSX users, see
directly below. Windows users, see page 9) If your operating system is not listed,
contact customer service for assistance.
Mac OS X
a. Go to top menu “Go” and select “Utilities”. The Utilities window opens. Select
“Disk Utility” to start the disk utilit y program.
4
b. Click the header on the left which starts with the drive size in gigabytes (1 ). Now
click on the “partition” tab on top (2). Disk Utility will sw itch to it’s partitioning
function pane. Now click on the dual arrow button under “Volume Scheme” (3).
Choose “1 partition” (4).
5
Loading...