Cathrein UFS 800 Quick Start Manual
IMPORTANT
READ CAREFULLY BEFORE USE
You will fi nd an English version of
this document at www.kathrein.com
Vous trouverez la version française
du document sur www.kathrein.com
Quick Start Guide
Connection and set-up
UFS 800
English
2 from 24
2 from 24
General safety instructions
List of Contents
1 General safety instructions ............................................................................2
2 About these instructions ................................................................................6
2.1 Contents ........................................................................................................................6
2.2 Explanation of the symbols and signal words ..........................................................6
2.3 Abbreviations and technical terms ............................................................................7
3 Items supplied .................................................................................................7
4 Inserting batteries into the remote control ...................................................8
5 Controls and connections ..............................................................................9
6 Connecting the receiver ................................................................................10
6.1 Preconditions .............................................................................................................10
6.2 Connecting the antenna cable ..................................................................................11
6.3 Connecting the TV set ...............................................................................................11
7 Initial set-up ...................................................................................................12
7.1 Remote control ...........................................................................................................12
7.2 Performing the initial set-up .....................................................................................13
7.3 Performing optional settings ....................................................................................14
8 Remote control functions .............................................................................18
9 Frequently Asked Questions ........................................................................20
10 Disposal ..........................................................................................................22
11 Copyright and licence conditions ................................................................23
1 General safety instructions
Warning
Risk of death due to electric shock and risk of fi res resulting from electric current.
Please note the following points:
Power cable
● Make sure that the mains cable (power supply cable) is not damaged or does
not become damaged.
● A unit with a damaged mains cable must be disconnected from the mains
(unplug it at the socket) and repaired by an electrical specialist before being
used again.
3 from 24
3 from 24
Power supply voltage
● Operate the unit only at the specifi ed mains voltage. The mains voltage is
shown on the rear of the unit or on the external power supply unit.
● The unit may only be connected to the mains and turned on once it has been
connected to the antenna and to the TV set or the cable network and PC.
Accessibility of the mains socket
Position the unit close to an easily accessible mains socket so that you can switch
off the power at any time if required.
Playing children
Make sure that children do not push any objects into the ventilation slots.
Cleaning
● Disconnect the mains plug before cleaning the unit.
● Never open the casing of the unit.
● Do not insert anything into the ventilation slots.
● Use a dry cloth for cleaning.
● Restrict cleaning to only the outer surface of the unit.
Ambient conditions
● The receiver and power supply unit are for indoor use only.
● The unit should be protected from damp, dripping water and splashing.
– Do not operate the unit in damp areas.
– Only use the unit in a moderate climate, not in tropical conditions.
– Do not place any vessels containing liquid (such as vases) on the unit.
Caution
Hazard due to electric shock and starting fi res. Please note the following points:
Repair
Ensure that any repairs to your unit are carried out by qualifi ed personnel.
● Improper work on the unit may jeopardise the electrical safety of the unit.
● The manufacturer accepts no liability for accidents caused by the user opening
the unit.
● Opening the unit and attempting to repair it yourself will void any warranty
claims.
4 from 24
4 from 24
General safety instructions
Earthing the antenna system
An incorrectly earthed antenna system can lead to overvoltage in the event of a
lightning strike. Earth the antenna system in accordance with regulations or connect an equipotential bonding conductor. When doing so, comply with EN 60728/11
and national regulations where applicable.
Caution
Risk of corrosion and explosion of batteries. If your unit is supplied with batteries
(for instance in the remote control), comply with the following points:
● Do not expose batteries excessively to sources of heat, direct sunlight or fi re.
● Comply with the safety instructions stated on the batteries:
● Replace the batteries only with types that are identical or equivalent,
Important
Risk of damage to the unit. Please note the following points:
Incorrect connections to the ports
Improperly connected connections can lead to operating faults or defects in the
unit.
Overheating
Comply with the following points, so that the heat generated in the unit is adequately dissipated.
● Unless stated to the contrary in the instructions supplied with the unit, maintain
the following clearances around it: 10 cm above it, 5 cm behind it, 2 cm to either
side.
● Never install the unit in a cupboard or on shelves with inadequate ventilation.
● Never cover or block the cooling slots on the unit or the fan (e. g. with other
equipment, magazines, tablecloths, clothing or curtains).
● Do not place any objects on top of the unit.
● Do not place the unit close to sources of heat, and do not place naked fl ames,
such as candles, on the unit.
● Do not expose the unit to direct sunlight.
Loss of data and software corruption if the receiver is disconnected from the
mains whilst it is in use
Always switch the receiver into stand-by mode by pressing the stand-by button (on/
off) on the remote control, before disconnecting it from the mains. This ensures
that any data that is new or has been changed will be saved by the receiver.
5 from 24
5 from 24
Long periods of absence or storms
● If you are going to be absent for a long time or if there is a storm, always switch
off the unit at the mains (have fi rst switched it into stand-by mode). Then pull the
plug out of the mains socket, so as to totally disconnect the unit from the mains.
This also applies to other equipment connected to the unit.
● We recommend also disconnecting the power cable and the antenna cable from
the unit.
Further points
Effects of the heat generated by the unit
● All electronic equipment generates heat. The temperature rise of this unit lies
within the permissible range. Sensitive furniture surfaces and veneers may however become discoloured by the effects of constant heat over time.
● The feet of the unit can cause changes to the colour of treated furniture sur-
faces. To avoid possible discoloration, place the unit on a suitable stable fl at
underlay.
Use of these instructions
● Read these instructions carefully before setting up the unit.
● Keep the instructions safe for future reference, and pass them on to any new
owner.
Product return/original packaging
Please keep the original packaging in case you need to return the product at any
time. Due to the nature of their construction receivers are fragile, and only the original packaging can be relied on to provide adequate protection. If the receiver is not
shipped correctly the guarantee/warranty on it will be voided.
Updates
The information in this manual was correct at the time of going to press. However,
we reserve the right to make changes at any time and without prior notice. If new
software which affects the information in this manual (e. g. changes to the menus
and/or functions) is released for your receiver, where we believe it necessary we
will make available a new manual for download under www.kathrein.com .
Make a note of the basic settings that you make when setting up the receiver for
the fi
rst time, so that you can restore them later if necessary.
6 from 24
6 from 24
About these instructions
2 About these instructions
2.1 Contents
This Quick Start Guide describes a quick and easy procedure for connecting the receiver to the
most popular satellite systems and then setting it up. All further details can be found in the comprehensive instructions for use at www.kathrein.com .
► Go to www.kathrein.com ▶ Satellite and terrestrial reception systems ▶ Product overview ▶
Receivers ▶ Satellite receivers (DVB-S).
The information about your receiver model can be downloaded from the product page.
2.2 Explanation of the symbols and signal words
2.2.1 Symbols
General warning sign
Tip
Instruction for installation or operation
of the unit, or for use of the instructions
Risk of damage to property
2.2.2 Signal words
The signal words are used in conjunction with the symbols shown above:
Warning This signal word indicates a hazard with a medium level of risk which can lead to
death or severe injuries.
Caution This signal word indicates a hazard with a low level of risk which can lead to
minor or moderate injuries.
Important This signal word indicates a hazard which can lead to damage to property.
7 from 24
7 from 24
2.3 Abbreviations and technical terms
DiSEqC DiSEqC (Digital Satellite Equipment Control) is a digital control signal system which
allows reception from more than 1 satellite.
Multiswitch
A multi-switch distributes the signals supplied by the LNB to the various different
sat receivers.
S/PDIF S/PDIF (Sony/Philips Digital Interface Format) is a digital interface for electrical or
optical transmission of digital audio signals such as Dolby Digital AC-3.
UTC UTC (Universal Time, Coordinated) is the coordinated world time based on the
London Greenwich zero meridian. Central European Time (CET) corresponds to
UTC+1:00. In summer the time used is Central European Summer Time (CEST)
which corresponds to UTC+2:00.
3 Items supplied
1
2
3 4
5
➊
Receiver UFS 800
➋
Quick Start Guide and Safety Instructions
➌
Remote control
➍
HDMI cable
➎
2 batteries AAA 1.5 V
The accessories supplied may differ in appearance from those illustrated.
Fig. 1: Scope of delivery (with packaging)
8 from 24
8 from 24
Inserting batteries into the remote control
4 Inserting batteries into the remote control
1. Remove the cover from the remote control. To do this, press on the point ② and push the
cover ① off to the rear ③ (Fig. 2).
2. Insert the batteries
④ supplied into the battery compartment ⑤. Ensure correct polarity of
the batteries (the polarity is marked inside the battery compartment).
3. Fit the cover again and slide it forward to the stop.
4
3
2
1
4
5
Fig. 2: Inserting batteries in the remote control (showing the principle)
Loading...