CATEYE PADRONE DIGITAL
Troubleshooting
Measurement does not work
The PADRONE DIGITAL does not switch to the measurement screen.
What should I do?
Is flashing on the PADRONE DIGITAL?
•
The PADRONE DIGITAL is connected to a smartphone.
Set [Connect] to [OFF] in the
Cateye Cycling™.
Why is the sensor signal not being received?
If using a smartphone (Cateye Cycling™), is [Connect] set to [ON] in the (Menu)?
•
Set [Connect] to [OFF] or close Cateye Cycling™.
(Menu) of the smartphone (Cateye Cycling™) or close
Are you using another smartphone application that is connecting to the
•
Bluetooth® sensor?
The Bluetooth® sensor may be connected to the smartphone.
Bluetooth® sensors are only able to connect with a single device at a time.
Stop using all other apps or change the app settings so that it does not connect to
Bluetooth® sensors.
Turn off Bluetooth® on your smartphone, as the sensor may be connected to the
•
smartphone.
Confirm that the sensor gets connected with the PADRONE DIGITAL.
It is recommended that Bluetooth® is turned off on your smartphone when the sensor
disconnects easily.
Are you also using other wireless devices simultaneously (including other Bluetooth®
•
products)?
Stop using the devices simultaneously and confirm that the connection is restored.
Press the RESET button on the sensor that cannot connect.
•
Confirm that the sensor gets connected with the PADRONE DIGITAL.
1
CATEYE PADRONE DIGITAL
Troubleshooting
Measurement does not work
Why is the sensor signal not being received? (Continued)
Is the sensor paired with the unit?
•
The sensor must be paired with the PADRONE DIGITAL. Perform the pairing with the
PADRONE DIGITAL or with a smartphone (Cateye Cycling™).
Caution!: Pairing of a commercial sensor and the PADRONE DIGITAL
If using a commercial sensor with an iPhone, go back to
OFF and perform pairing with the PADRONE DIGITAL.
* When using an iPhone, you cannot sync settings of commercial sensors with the
PADRONE DIGITAL.
Is the PADRONE DIGITAL or sensor battery flat?
•
* Battery performance diminishes in winter.
Replace the batteries with new ones.
If speed sensor signals or cadence sensor signals are not received
Is the clearance between the sensor zone of the sensor and the magnet too large?
•
(The clearance must be within 3 mm.)
Does the magnet pass through the sensor zone correctly?
•
Adjust the position of the magnet and/or the speed sensor.
If heart rate signals are not received
The electrode pad may have slipped out of position.
•
(Menu), set [Connect] to
Check that the electrode pad is still in close contact with your body.
Your skin may be dry.
•
Wet the electrode pad a little.
The electrode pad may have deteriorated or become damaged due to prolonged usage.
•
If this is the case, replace the attachment belt with a new one.
2
Loading...