CatEye HL-EL620RC User Manual

RECHARGEABLE

HEADLIGHT

Nano Shot

HL-EL620RC

Copyright© 2012 CATEYE Co., Ltd. EL62RC-120521

3

ENG

1

2

3

1 sec.

Double press

*2

*2

OFF

1 sec.

ON

Flash

Hi Low

*1

Switch

(indicator) state

Standard

charging time

(For USB2.0)

ON : Charging
OFF : Charging is

completed

Approx. 3.5 hours

SPARE PARTS

OPTION PARTS

5338827N

FlexTight™ bracket (H-34N)

5341831N

Helmet mount

Remove the charging jack cover on the

1

back of the light, and connect the light unit
and your PC, or a commercial USB battery
charger with the USB cable.
The switch lights up, and charging starts.

When your PC is in sleep state, the unit *
cannot be charged.

With USB1.0, it takes time to charge.*

When the switch lights off, charging is

2

completed.
Remove the USB cable, and install the
charging jack cover.

Charging and lighting times are approxi-*
mate values, and will vary by environmen­tal and user conditions.

Switch operation (switching the lighting mode)

The ON/OFF and lighting modes are selected using a switch.

Switch operation Standard operating time

ON ↔ OFF : Long press
Hi ↔ Low : Single press
Flash : Quick double press

(Flash even from OFF)

Hi : Approx. 1.5 hours
Low : Approx. 3 hours

Flash : Approx. 12 hours

Wind the bracket strap around the handle-

1

bar, and put the strap through the opening.
Screw the dial into the bracket to secure it

2

temporarily.

Insert the light unit to the bracket until *
it clicks, and adjust the beam angle.
(Refer to “HOW TO MOUNT THE
LIGHT”)

Securely tighten the dial, and cut off any

3

excess bracket strap.

To remove the light unit, pull out it forward *
while pressing the button.

To re-adjust the beam angle, loosen the

*

dial enough to move the bracket, and
securely tighten it after adjustment.

CAUTION!:

Be sure to tighten the dial by hand. When •
you tighten it too hard with a tool, the
screw thread may be stripped.

Ch eck the dia l and scr ew (*1) on the •
bracket periodically, and use them with­out any loosening.

Roun d off the cut edg e of the bra cket •
strap to prevent injury.

HOW TO CHARGE

HOW TO MOUNT

HOW TO USE

HOW TO REPLACE THE BATTERY

When the operating time decreases signifi cantly, the battery life is close to an end. Please contact
CatEye local distributor listed on our website www.cateye.com or CatEye for replacing battery.

CAUTION!: The light unit is a precision device. Never disassemble it.

SPECIFICATIONS

Light source High-intensity white LED x 1
Battery Li-ion 3.7v 1110mAH
Charge Mini USB plug

Operating time

Hi : Approx. 1.5 hours
Low : Approx. 3 hours
Flash : Approx. 12 hours

Standard charging time

Approx. 3.5 hours (USB2.0)

Temperature range

Charging : 41˚F – 104˚F (5˚C – 40˚C)
Operating : 14˚F – 104˚F (-10˚C – 40˚C)

Recharge/discharge number of times About 300 times (until the rated capacity drops to 70%)

Dimensions/weight

3-25/64” x 1-31/32” x 1-17/64” (86 x 50 x 32 mm) / 2.8 oz (80 g)
(Including rechargeable batteries supplied)

The specifi cations and design are subject to change without notice.*

DISPOSE BATTERY

3

1

2

1

USB cable

To PC or USB
battery charger

Charge jack cover

Dial

Rubber pad

Bracket

Strap

Release
button

HOW TO MOUNT THE LIGHT

Screw

Switch
(indicator)

Battery

Battery

1

2

3

2-8-25, Kuwazu, Higashi Sumiyoshi-ku,
Osaka 546-0041 Japan
Attn: CATEYE Customer Service Section
Phone : [phone]
Fax : [phone]
E-mail : [e-mail]
URL : http://www.cateye.com

[For US Customers]
CATEYE AMERICA, INC.

2825 Wilderness Place Suite 1200,
Boulder CO80301-5494 USA
Phone : [phone]
Toll Free : 800.5CATEYE
Fax : [phone]
E-mail : [e-mail]

CO

., LTD .

Before using the light, please read this manual and the attached “Lithium-ion Bat­teries” thoroughly, and keep them for future reference.

LIMITED WARRANTY

2-year Warranty: Light unit only (Deterioration of the battery is excluded.)

CatEye products are warranted to be free of defects from materials and workmanship for a period of 2 years from
original purchase. If the product fails to work during normal use, CatEye will repair or replace the defect at no
charge. Service must be performed by CatEye or an authorized retailer. To return the product, pack it carefully and
enclose the warranty certifi cate (proof of purchase) with instruction for repair. Please write or type your name and
address clearly on the warranty certifi cate. Insurance, handling and transportation charges to CatEye shall be borne
by person desiring service. For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase.
This does not affect your statutory rights.

Please register your CatEye product on the website.

http://www.cateye.com/en/support/regist/

CAUTION!

Before your trip, please make sure the light is fi rmly mounted to the bracket, it •
lights up, and the light is not blocked by baggage, etc.

Do not place it within children’s reach.•
In preparation for unexpected battery shutoff, we recommend you carry a spare light.

•
Mount the light unit more than 7 cm away from the wireless meter. When it is •

mounted too close, the transmission may be affected adversely.
This product is water-resistant under normal daily use and can be used in the •

rain. However, do not intentionally submerge it in water.
If the light unit or parts become dirty with mud, etc., clean with a soft cloth •

which is moistened with mild soap. Never apply paint thinner, benzine or alco­hol; damage will result.

Remove the used battery and bring it with the connector covered with an insula-•
tion tape to the store supporting rechargeable battery recycling.

Before Initial Use
This unit is shipped with a small charge to check the light. Be sure to charge it be­fore use, according to the instructions “HOW TO CHARGE”.

Light unit

FlexTight™ bracket

(H-34N)

USB cable

*2 When returning from ON to OFF, or Flash to ON (Hi or Low), it returns to the light-

ing mode used previously.

Remaining battery capacity

When the switch (indicator) lights up, the remaining battery level is low. Please
charge as soon as possible.