Model CPA QA-20
Owner Operation and
Maintenance Manual
IMPORTANT
Read and save these instructions.
Always unplug the CPA QA-20 Air Purification System when it is not in operation, while
the Filters or UVC germicidal lamps are being changed, and when cleaning. After
servicing this equipment both the front and top grill assemblies must be reinstalled in
exactly the same manner as prior to removal. If either grill is not reinstalled properly the
Catalytic Pure Air Portable Air Purification System will not turn on. This is a built in
safety feature.
Before using the Catalytic Pure Air Portable Air Purification System extend the power
cord and inspect for any signs of damage. Do not use the product if the power cord has
been damaged.
Warning - This appliance is designed to be used on a flat level surface, and may not
work properly on an uneven surface. To reduce the risk of electric shock and injury, do
not place in a window. Always place the air purifier at least 12 inches (30.48
centimeters) away from heat sources such as stoves, radiators, or heaters.
SAFETY
INSTRUCTIONS
Do not move the Catalytic Pure Air Portable Air Purification System while it is in
operation.
Always unplug prior to moving.
Do not immerse the Portable Air Purification System in water, as permanent damage
will occur. Refer to the "Performing Maintenance" section in this owner operation and
maintenance manual.
P.2
CATALYTIC
SYSTEM FEATURES
Thank you for purchasing a Catalytic Pure Air Portable Air Purification System.
The CPA QA-20 Portable Air Purification System incorporates unique air-purification
technologies not found in any other air purifier. The PCO-Cell patented catalytic
technology significantly reduces the presence of irritable and toxic airborne gaseous
contaminants produced by common household cleaners and materials.
• A quiet, energy-efficient backward-curved impeller that moves 265 cubic feet of air
per minute.
• An advanced electronic control system that monitors air quality, air flow and volume,
filter and UVC germicidal lamp replacement time.
• A five-stage filtration system with gas-absorption media that absorbs toxic gas,
organic hydrocarbons, exhaust fumes, formaldehyde, cleaning chemicals, low level
ozone, unpleasant odors, and paint solvents.
PURE
AIR
PORTABLE
AIR PURIFICATION
. A hospital-grade three-stage HEPA filter removes allergens such as pollen, mold
fungal spores, tobacco smoke, insecticide dust, dust mites, and particles down to 0.3
microns (0.00003 inch).
• The PCO-Cell photo-catalytic oxidation chamber reduces the spread of airborne
disease in the home environment. The powerful UVC germicidal light has 150 times
the ultraviolet intensity of bright sunlight which kills viruses and bacteria on contact.
• Oxygen in the air, combined with photo-catalytic technology and UVC germicidal
ultraviolet light, oxidizes airborne impurities too small to be filtered-out.
The PCO-Cell photo-catalytic oxidation technology which has received six patents from
the USPTO, will keep the air clean and fresh in exactly the same way sunlight and
oxygen clean the air we breathe in the outdoor environment.
P.3
INSTALLING
THE
CATALYTIC
PURE
AIR
PORTABLE
AIR PURIFICATION
SYSTEM
CAUTION
This product is for indoor use only.
Before unpacking the product, inspect the shipping container for visible damage. If you
feel that you may have received the product in a damaged condition, notify the shipper
or supplier before opening the container. Remove the product from the box and inspect
it for damage.
Handle it carefully. Do not drop!
Place the Purifier in a location that will not restrict air flow through either the air inlet or
the air outlet, then plug-in the electrical cord at the nearest electrical wall outlet.
NOTE:
functions
unplugged
The CPA QA-20 air purifier
when plugged in to the wall
from
the wall and reinstalled.
will
perform
outlet.
a diagnostic test of indicator lights and
This
will
only happen
once
unless
the
system
is
FIGURE
1.
Press-in
(figure
2.
Look into the air outlet at the top of the CPA QA-20 PCO Air Purification System and
Power (ON/OFF)
button
1) will turn-on and the UVC germicidal ultraviolet lamp will be on.
1.
to turn-on the Purifier. Lights on the control panel
confirm that the UVC germicidal ultraviolet lamp is on. You will see a faint blue glow
when the lamp is on.
When the UVC germicidal ultraviolet lamp is on, the product is ready for operation.