CASP ELEKTRONIK MAL15776, MAL 15776G, MAL17776, MAL17776G, MAL19776 User Manual

Marine Display User’s Manual

Marine Line

MAL15776, MAL 15776G,

MAL17776, MAL17776G,

MAL19776, MAL19776G

0

Preface

1

Product features

2

Intended markets

3

Safty Precautions

3

Regulatory requirements and approvals, labeling

7

FCC Information

8

Warrenty and Limitation of Liability

8

Cleaning the Product

9

Disposal of the Product

9

Getting started

10

Input signals

12

OSD Adjustment Functions

14

Chart of OSD Adjustment Functions

16

Applicable Signal Timings

18

Specifications

20

Special Considerations for LCD Panels

27

Troubleshooting

29

Contact information

31

Contents

1

Preface

Thank-you for purchasing this LCD Monitor.

To get the full benefit of the features that this product offers you, it is important that you read this
User’s Manual which, among other things, will explain how to properly install and operate the
monitor. In this user guide there are detailed product specifications, explanations for many of
the technical terms used in this manual as well as information on regulatory approvals, cleaning,
service instructions, warranty terms, waste disposal and some other useful information.

It is of utmost importance that you carefully read and follow the safety instructions and
safety notices included in this User´s Manual.

Failure to comply with these instructions could in some instances cause bodily harm to yourself
or other persons and/or un-repairable damage to the product or to other attached devices /
appliances.

Throughout this manual the following symbols are used to guide you to the proper use of the
product:

Symbols

Expresses DO NOT.

Person could be at risk of
severe injury or death.

Caution

Person or properties could be
at risk of injury or damage.

Expresses MUST DO.

Warning

Keep this Users Manual in an easy accessible and safe place for future reading of it. If you lose
your copy, you may request a new one by contacting us at our internet home page
www.caspelektronik.com

We reserves the right to change the specifications of this product without any notice. Such
changes could cause the operation of the product to be slightly different from the descriptions in
this copy of the Users Manual.

Windows and MS-DOS are trademarks and/or registered trademarks of Microsoft Corporation in
the United States and/or other countries. VESA is a trademark of the Video Electronics Standard
Corporation. All other product and company names are trademarks of their respective owners.

Copyright © 2012

2

Product Features

Standard delivery

The product is normally delivered in 1 main part.

• a LCD panel with TFT picture element which also contains the lamps for the backlight along
with necessary electronics and cable connectors as well as power connector. These parts are
mounted inside a plastic housing.

For marine applications, when the monitor is to be placed on a wall or built into a desk, then only
the LCD panel part is delivered. In these cases it is quite often delivered with the plastic housing

removed in what is called “open frame”. Certain other options or special mounting components

might have been pre-installed.

Warning

When the monitor has been delivered as open frame there is a greater risk to come
in contact with electric parts which could cause harm to yourself or your property. It
should therefore only be handled with special precaution and only by properly trained
service personnel.

Power management

This unit has power management system. The monitor will go into “sleep mode”, where power
consumption is less than 5W, whenever either horizontal or vertical signals or both disappear.

High performance panel element

The color LCD panel used in this product is specifically designed for advanced applications such
as video and marine dimming

Protective glass for MAL15776, 17776, 19776

The marine versions of the product can be fitted with a protective glass for easy cleaning and
protecting. (G-version)

Ergonomic features

To ease eyestrain on the user, the panel features excellent viewing angles.

VESA® standard wall / arm mountings

The unit is compliant with VESA’s 100mm-pitch (75 mm for 15” monitors) for hanging tools. The
panel can be mounted on a wall or arm according to user’s environment.

Safety Precautions

3

This product has been designed and developed for use as a visual output device for direct
connection to a Personal Computer and PC compatible devices as well as other video generating
equipment, such as cameras. The product will accept industry standard video signals coming over
cables with industry standard type connectors. The product will operate and function properly in
normal office environment and under conditions as specified in the Product Specification chapter.

Warning

Attempting to use the product for any other purpose than its intended use or
connecting to other devices could cause damage to the product and / or to other
property and equipment. There could also be a risk of bodily harm to yourself or other
persons.

The product operates on 12V (some on 24V) DC power and must be connected thru the AC 100-
240V, 50-60Hz to12V DC adapter (or 24V DC adapter) which is included with the product. Power
to the adapter should be coming from an ordinary grounded AC 100-240V power outlet.

Warning

Never try to connect the product to any other power source than the 12V/24V adapter
delivered together with the product. There would be a risk of electrical shock which
could cause bodily harm, possibly even death. Most certainly such electrical shock will
damage the product.

The product can also be delivered with certain options installed. Such options could be touch
panel or other special accessories.

All other uses of the product, including but not limited to attempts such as;

Warning

• connection to other types of power sources

• using other types of mounting or placement of the product

• connection to other devices than those for which the monitor has been

designed.

will void any and all warranties of the product and the manufacturer will not be
responsible or libel for any bodily injury or property damage either directly or
indirectly caused by such non-intended use of the product.

Intended Markets

These products are developed primarily for sales and installation in countries within Europe and
North America. The products comply with all regulations and directives issued by the European
Union and by authorities in the United States.

Warning

The products are not intended for sales and/or installation in countries, which require
other or additional mandatory approvals than those required by the authorities of the
European Union or the United States.

Consult the product identification label or product specification for regulatory approvals that apply
to this product.

Safety Precautions

4

It is important that you read through the following notes of Safety Precautions to avoid any
damage to the Product, yourself or other property. Following these precautions will also ensure
that you get the best use of the Product.

Warning

DO NOT OPEN THE PRODUCT. There are no user serviceable parts inside. Because
of high voltage inside there is a risk of bodily injury or death. Only authorized and
qualified service personnel should maintain the product.

Cautions when setting up

Do not put the unit on unstable places (on a wonky table or in an inclined
place), which might cause injuries if it falls down.

Caution

Caution

Do not place the unit where it is subject to direct sunlight or near any
heating device. This could cause overheating resulting in damage to
the product and eventually causing a fire.

Cautions when using

Do not put the unit in such a place where there is bad air circulation,
dust, humidity, oily smoke or steam. It may lead to a fire.

Warning

Caution

Caution

Do not put any metal materials or flammable foreign objects into the
unit through the vent holes. It may lead to electric shock and/or fire.
Immediately disconnect the unit from the power outlet and contact your
local re-seller for service.

Scratching or hitting with hard objects may damage the unit.

Safety Precautions

5

Warning

Caution

Do not use the unit turned over on its back, put on its side, or upside
down. These positions may cause the heat that the unit generates to
accumulate inside the unit. Such overheating can cause damage to the
product and eventually start a fire.

When using the unit for several hours, you should take a 10-15 minute
break every hour to reduce eyestrain. Failure to do so could cause injury to
your eyes.

Abnormal circumstances

In case of any abnormality such as odor, sound, and overheat taking
place, immediately turn off the power and disconnect the plug from
the outlet. Continuing to use the unit under such condition may lead to

Warning

Warning

Warning

electric shock and/or fire. For assistance contact your local re-seller.

In the event of thunder, immediately turn off the power and
disconnect the plug from the outlet. Lightning strikes may cause
electric shock and/or fire.

In the event of broken panel and leaking liquid crystal, do not inhale,
swallow, or touch the liquid crystal. It may cause you to get poisoned
and/or having a skin irritation. If you put it in your mouth, immediately
gargle with water and contact a doctor to get a checkup. In case of
getting it on your skin and/or cloth, wipe it off with alcohol and rinse
them.

Safety Precautions

6

Maintenance

Do not remove the plastic cabinet. There are high voltage parts inside
that may lead to electric shock. Ask a re-seller for adjustment and
inspection.

Warning

Warning

Caution

Do not remodel or repair. It may lead to fire, electric shock, or injuries.

Clean the dust inside the display once a year. The dust that accumulates
inside the unit may lead to fire. Ask a re-seller for adjustments and
inspection.

Disconnect the plug from the outlet when you do not use the unit for a
prolonged period.

Caution

7

Regulatory requirements and approvals

All products have normally been tested to comply with all mandatory Regulatory requirements
for the markets where the products are sold. Approvals are listed by each Regulatory Agency
under the name of the manufacturer and model number as specified on the Product
Identification Label.

Approvals applicable for this product is listed in the Product Specification section of this
manual.

Tests and Approvals for Marine Line Series

Each product in the MarineLine series has been tested as an IT-category product for normal
office environment and for use as a desktop monitor. They comply with the following standards
and regulations:

• CE for use within the European Union member states

• UL for use in the United States

• FCC for use in the United States

• WEEE for use within the European Union member states

• RoHS for use within the European Union member states

Label

The below label will be behind the hatch, showing approvals and serial number.

8

FCC Information

FCC (U.S. Federal Communications Commission)

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy,
and if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause unacceptable interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult your re-seller or an experienced radio/TV technician for help.

FCC Warning:

To assure continued FCC compliance, the user must use a grounded power supply cord and the
provided shielded video interface cable with bonded ferrite cores. Also, any unauthorized changes
or modifications to this monitor would void the user’s authority to operate this device.

Warranty and Liability

Warranty

For details of the warranty please see the separate warranty document included with this product.

Limitation of Liability

Casp Elektronik, including any of its affiliates, manufacturing partners and sales agents, is not
liable for any claim for damages including, but not limited to, loss of business profits, disruption of
business, change or loss of saved data, when damage is arising from

• fire, earthquakes, actions taken by any third party, any other accidents, intentionally

or negligently, improper use of the product by the user, or any use under other abnormal
circumstances,

• the use or inability to use this product,

• the use for other purposes than the intended use as described in this document

• malfunctions caused by the combination of connected devices