Casio MA1002-EA User Manual

MA1002-EA

Operation Guide ANALOG (MAB)

Your watch may differ somewhat from the one shown in the illustration.•

Notes

Some water resistant models are equipped with a screw lock •
crown.
With such models, you must unscrew the crown in the direction •
noted in the illustration to loosen it before you can pull it out.
Do not pull too forcibly on such crowns.
Also note that such watches are not water resistant while their •
crowns are loosened. Be sure to screw the crowns back in as
far as they will go after making any setting.

[

Module 5128

To set the time

To set the day

[Modules 5125 and 5167]

To set the time

To set the day and day of the week

]

When the second hand is at 12 o’clock, pull out the 1.
crown to the second click to stop it.
Set the hands by rotating the crown. Move the 2.
minute hand four or five minutes past the setting
you want, and then back them up to the setting.
Push the crown back in on a time signal to resume 3.
timekeeping.

Avoid setting the day between 9:00 p.m. and 1:00 •
a.m. The day may not change in the following day if
you do.

Pull out the crown to the first click.1.
Set the day by rotating the crown.2.
Push the crown back in to its normal position.3.

When the second hand is at 12 o’clock, pull out the 1.
crown to the second click to stop it.
Set the hands by rotating the crown. Move the 2.
minute hand four or five minutes past the setting
you want, and then back them up to the setting.
Push the crown back in on a time signal to resume 3.
timekeeping.

Avoid setting the day and day of the week between •
9:00 p.m. and 5:00 a.m. The day and day of the
week may not change in the following day if you do.

Pull out the crown to the first click.1.
Set the day by rotating the crown counterclockwise.2.
Set the day of the week by rotating the crown clockwise.3.
Push the crown back in to its normal position.4.

First click (Day setting)

Crown
(Normal position)

Second click
(Time setting)

First click
(Day, day of week setting)

Crown
(Normal position)

Second click
(Time setting)

For watch with the elapsed time bezel •
Rotate the elapsed time bezel to align the
minute hand.
After certain amount of time elapsed, read the graduation on the
elapsed time bezel which the minute hand points to.
The elapsed time is indicated.

mark with the

Elapsed time bezel

Specifications

Module No.

5125/5128 ±20 seconds SR626SW Approx. 3 years

5167 ±20 seconds SR920SW Approx. 5 years

Accuracy at normal

temperature

(per month)

Battery type Battery life

1