Casio 5448, 5359 User Manual

MA1904-EA

Operation Guide 5359/5448

x Be sure to keep all user documentation handy for future reference. x Your watch may differ somewhat from the one shown in the illustration.

Day

Click 2

Click 1

Crown

To adjust the time setting

When the second hand is at 12o’clock, pull the

Crown out to Click 2.

Rotate the Crown to change the time setting.

Push the Crown back in on a time signal to resume timekeeping.

Note

x Take care that you set the

correct AM or PM time.

x When changing the time,

move the minute hand four or five minutes past your final setting, and then back it up to the setting you want.

Crown Operations

Some water-resistant models (100meters, 200meters) have a screw-in crown. When you need to perform a crown operation, rotate it towards you to unscrew it. Then pull the crown out. Avoid applying undue force when pulling. The watch loses its water resistance while the crown is unscrewed. After performing a crown operation, fully screw the crown back in.

If your watch has a rotary bezel...

You can rotate the bezel to align its ▼ mark with the minute hand. Then you will be able to tell how much time has elapsed since aligning the ▼ mark.

Current

Crown

Loosen

Start

Elapsed time

Specifications

Accuracy: ±20seconds average per month Battery: Module 5359: One silver oxide battery (Type: SR916SW)

Module 5448: One silver oxide battery (Type: SR920SW)

Battery Life: Approximately 3years [Module 5359]

Low Battery Indicator: Second hand moves in 2-second increments when power is low.

Specifications are subject to change without notice.

To change the day setting

Pull the Crown out to Click 1.

Rotate the Crown to set the day.

Push the Crown back in.

Note

x The day setting uses a

31-day month. Make adjustments for months of shorter lengths.

x Avoid changing the day

setting between the hours of 9 p.m. and 1 a.m. Otherwise, the day setting may not change correctly at midnight.