MA1904-EA © 2019 CASIO COMPUTER CO., LTD.
Operation Guide 5359/5448
xBe sure to keep all user documentation handy for future reference.
xYour watch may differ somewhat from the one shown in the illustration.
Day
Click 2
Click 1
Crown
Crown Operations |
Crown |
Some water-resistant models (100 meters, 200 meters) have a screw-in crown. When you need to perform a crown operation, rotate it towards you to unscrew it. Then pull the
crown out. Avoid applying undue force when pulling. The watch loses its water resistance while the crown is unscrewed. After performing a crown operation, fully screw the crown back in.
If your watch has a rotary bezel...
You can rotate the bezel to align its ▼ mark with the minute hand. Then you will be able to tell how much time has elapsed since aligning the ▼ mark.
Current
Loosen
Start
Elapsed time
Specifications
Accuracy: ±20 seconds average per month
Battery: Module 5359: One silver oxide battery (Type: SR916SW)
Module 5448: One silver oxide battery (Type: SR920SW)
Battery Life: Approximately 3 years
[Module 5359]
Low Battery Indicator: Second hand moves in 2-second increments when power is low.
Specifications are subject to change without notice.
To adjust the time setting
When the second hand is at 12 o’clock, pull the Crown out to Click 2.
Rotate the Crown to change the time setting.
Push the Crown back in on a time signal to resume timekeeping.
Note
xTake care that you set the correct AM or PM time.
xWhen changing the time, move the minute hand four or five minutes past your final setting, and then back it up to the setting you want.
To change the day setting
Pull the Crown out to Click 1.
Rotate the Crown to set the day.
Push the Crown back in.
Note
xThe day setting uses a 31-day month. Make adjustments for months of shorter lengths.
xAvoid changing the day setting between the hours of 9 p.m. and 1 a.m. Otherwise, the day setting may not change correctly at midnight.
1