Casio 5267 Operation Guide

MA1110-EA

Operation Guide 5267

••Your watch may differ somewhat from the one shown in the illustration.

Hour hand

To set the time

Minute hand		1. Pull the crown out to the
		second click when the second
		hand is at 12 o’clock position
	First click	and the second hand stops.
	(Setting Day)	2. Set the hands by rotating the
		crown. Rotate the crown to
		move the hands clockwise.
	Second click	Move the minute hand four or
		five minutes past the time you
	(Setting Time)	want to set, and then back it
		up to the proper setting.
	Crown	••Carefully set the time,
Day	(Normal position)	making sure to distinguish
Second hand		between AM and PM.
		3. Push the crown back in to the
		normal position.

To set the day

1.Pull the crown out to the first click.

2.Set the day by rotating the crown.

3.Push the crown back in to the normal position.

••Avoid changing the date setting while the current time is between 9:00 p.m. and 3:00 a.m.

Using the Stopwatch

Stopwatch minute hand

Stopwatch hour hand

Stopwatch 1/5-second hand

The stopwatch lets you measure elapsed time up to 11 hours, 59 minutes, 59.80 seconds.

To measure elapsed times with the stopwatch

3TART

3TOP

2E START

3TOP

#LEAR

■■For a watch with an elapsed time bezel

Rotate the elapsed time bezel to align the mark with the minute hand. After certain amount of time elapsed, read the graduation on the elapsed time bezel which the minute hand points to. The elapsed time is indicated.

Elapsed time bezel

••Some water resistant models are equipped with a screw lock crown.

••With such models, you must unscrew the crown in the direction noted in the illustration to loosen it before you can pull it out. Do not pull too forcibly on such crowns.

••Also note that such watches are not water resistant while their crowns are loosened. Be sure to screw the crowns back in as far as they will go after making any setting.

Specifications

Accuracy at normal temperature: ±20 seconds a month

Display: 3 analog hands (timekeeping hour and minutes, stopwatch 1/5-second),

3 dials (timekeeping seconds, stopwatch hours and minutes), Day indicator

Stopwatch function: Measuring capacity: 11:59'59.80" Measuring unit: 1/5-second Measuring mode: Elapsed time

Battery: One silver oxide battery (Type: SR936SW)

Approximately 3 years on type SR936SW (assuming one stopwatch operation 60 min./ day)

1