Casall 91023 User Manual

INDOOR BIKE

91023

MANUAL

INSTRUCTIONS FOR USE

1) The model 91023 is designed to be used as a group cycle in fitness studios and health clubs.
It has a fixed wheel driven flywheel and should only be used under professional supervision.

2) Installation – it is important that the 91023 is correctly assembled
and we recommend that installation and assembly be carried out by suitably qualified personnel.

3) Handlebar and seat adjustment. It is important that the handlebar and seat are
set at the correct height for your body. Ask your instructor for assistance.
Adjusting the handlebar height - Make sure it is securely tightened and that there
is no lateral or vertical movement of the handlebar. Undo the Quick Release knob
which is located in front of head tube.Slide the handlebar/stem up or down to the
required height and then retighten.

The handlebar/stem position can also be adjusted forwards or backwards. Undo
the Quick Release lever located on below the slider. Slide the handlebar/stem
assembly forwards or backwards until you reach the required position. Then
securely re-tighten the Quick Release lever.

Adjusting the seat height – refer to above mention.

NOTE: there is a safety line engraved on the seat post. On no account
should the seat post ever be raised above this line.

4) Pedals and toestraps – your feet should be securely positioned in the toe clips
during the exercise. Put your foot as far forward as you can into the toe-clip and then pull the strap tight.

5) Resistance system- 91023 indoor bike is with durable belt direct drive transmission system,
to adjust the exercising resistance on the completed indoor bike, undo the simply loosen
or tighten using adjustment knob. Press down the brake lever for stopping the wheel

6) The 91023 should operate on a level surface with no lateral movement.
There are height adjuster pads located on either side underneath the rear foot.
Turn these pads clockwise or anti-clockwise until the bike is totally stable on the ground.

7) Maintenance – like any other mechanical cycling device, the 91023 should be
regularly maintained. Ask your supplier for a detailed maintenance programme.

91023 Assembly Diagrams

78

3

6

70R

62R

3A

6

16

17

11

15

70L

39A

20

12

74