Safety and the proper operation of y our Casablanca fan both requir e a thorough knowledge o f the product
and proper installation; therefor e, bef ore attempting to install and operate your Casablanca f an, read this
owner’s manual completely and carefully. Retain this manual for future reference.
CAUTION: To avoid possible electrical shock, make certain that electricity is turned off at
the circuit breaker or fuse box before attempting any installation procedure.
BEFORE YOU START
• All wiring must be in accord ance with th e Nati onal Electri c Code ANSI/NFPA 70-1993 and the appropri ate local electrical
codes. The N ati on al Electric Code requires proper groun din g as a precauti on again st electri cal sh ock. A qu alifi ed electrician should be consulted if you are unsure.
• This fan is design ed to be installed on an existing electrical outlet box. The outlet bo x m ust be UL Listed for ceilin g f an
installations , if it is not, a n ew box must be in stalled. Casablan ca extensi on poles are available f or sloped or high ceiling
installations.
• This ceiling fan requires a grounded electrical supply of 120 VAC, 60 Hz and a minimum 15 amp circuit. The maximum
current requirement for the fan with light fixture is 3.8 amps. The fan uses about 1 amp or 100 watts. Maximum light
current is 2.8 amps or 340 watts of lighting.
• Where wire n uts are employed , be sur e all bare wir es are within th e conn ectors. Wh en in stalling th e canopy hatch, m ak e
sure all wires are within the canopy and that no wires are being pinched.
For best performance and for your warranty to be valid,
use only genuine Casablanca blades, light fixtures, and accessories.
• The blades in each pack are m atched for equal
weight to assure smooth fan operation. If
more than one fan is being installed, be
careful not to mix blades from different
cartons.
• Inspect the contents of your carton for
possible shipping or handling damage and
report any such damage directly to your
authorized Casablanca dealer.
• It is always a good id ea to have an assistant
to help with the installation.
• When cleaning, painting, or working near
your fan, be very careful of th e fan and blades.
Always turn the power OFF to the ceiling f an
before servicin g it, working on it, or replacing
light bulbs.
• Never insert anything into the path of the
fan blades while the fan is in operation.
• Never install a fan over a pool or spa.
• Never operate a fan that has been damaged
in any way . Contact Casablanca Fan Compan y
by calling toll free 1-888-227-2178, or
contact your local authorized Casablanca
dealer for assistance in obtaining service.
1
P/N 1943650 REV. D P/D DEC00PDG
SAFE USE
FUSE BOX
(REMOVE FUSE FOR THE
CIRCUIT YOU WILL BE
WORKING ON)
CIRCUIT BREAKER
(TRIP BREAKER FOR THE
CIRCUIT YOU WILL BE
WORKING ON)
18″
70″
84″
CAUTION: MOUNT WITH THE LOWEST MOVING
PARTS AT LEAST 2.5 METRES ABOVE FLOOR OR
GRADE LEVEL.
ATTENTION: INSTALLER DE SORTE QUELES
PIÈCES INFÉRIEURES SOIENT À AU MOINS 2.5
MÈTRES AU-DESSUS DU PLANCHER OU DU SOL.
MOUNTING RECOMMENDATIONS
32°
Before moun ting your Casablan ca f an, read th e f ollowin g help ful recomm en dati on s. Th e locati on o f the f an, air cir culation,
and fan size are all important factors to consider before installation.
Location
Ceiling fans have pr actical uses in alm ost every r oom in your h om e . We suggest you follow these moun ting recommendations as you decide where to install your Casablanca fan.
• For safety reasons, the fan blades must be a minimum of 7′ above the floor.
• Do not locate the fan in a doorway or above a swinging door.
• In any installation, the tips of the blades must be at least 18″ from the wall in order to provide
sufficient clearance for the blades.
• In bedrooms, fans work best when mounted above the foot of the bed.
• Over pool tables, be sure to provide plenty of clearance to avoid damage from
pool cues.
• In kitchens be sure to allow for open cupboard doors to clear the fan blades.
• Do not install a fan close to, or over, a pool or spa. High humidity combined
with corrosive gases will destroy the finish and warp the blades.
Fan Size
Variable f an speed capability permits the use o f a full-size 52″ fan even in sm aller
rooms. For very large rooms, two fans may be needed.
SLOPED CEILING INSTALLATIONS
MAXIMUM
Suggested Extension Pole Lengths
Ceiling Height
8′
8′ 6″
9′
9′ 6″
10′
11′
12′
13′
14′
Pole Length
Standard
Standard
6″
12″
12″
18″
24″
36″
48″
EXTENSION
POLE
HANG-TRU®
ANGLE 32º
BLADES MUST BE A
MINIMUM OF 7′
ABOVE THE FLOOR
When to Use Extension Poles
For best performance an d best appearance,
an extension pole should be used with
your Casablanca fan when installing on
high (cathedral) ceilings or sloped ceilings. Casablanca offers standard poles in
increments of 6″ up to 5′. Custom poles
are available in lengths up to 10′. See your
Authorized Casablanca Dealer f or details.
Note: Fan may wobble or vibrate if
pole length is not long enough and
inside blade is too close to downslope
or side wall. Extending pole length
will usually solve problem.
Calculation of 32°
Use the tear-off Ceiling Angle Template card inserted in the
back of this manual, it provides you with a simple ‘go’ or
‘no-go’ for installing your fan on a sloped ceiling.
EXAMPLE 1
This slope is less than 32°.It is OK to install your fan.
EXAMPLE 2
This slope is 32°.This is the maximum slope thatwill allow the fan to hang straightdown. It is OK to install your fan.
EXAMPLE 3
This slope is more than 32°.Your fan will not hang straight down,an adaptor is necessary.Contact you local AuthorizedCasablanca Dealer in regards topurchasing a 'Slope Ceiling Adaptor'.
7′ MINIMUM
EXAMPLE 1
This slope is less than 32˚.
It is OK to install your fan.
EXAMPLE 2
This slope is 32˚. This is the maximum
slope that will allow the fan to hang
straight down. It is OK to install your
fan.
EXAMPLE 3
This slope is more than 32˚.
Your fan will n ot han g str ai gh t down, an
adaptor is necessary. Contact your local
Authorized Casablanca Dealer in regards
to purchasing a “Slope Ceiling Adaptor.”
2
STEALTH
®
STEALTH INSTALLATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, r emove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
PERMA•LOCK™ HARDWARE
ALLEN SET SCREW
1
⁄4-20 x 1⁄4"
(PRE-INSTALLED)
3mm
ALLEN WRENCH
FAN PREPARATION
IMPORTANT SAFETY INFORMATION!
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, INSTALL THE
THREADED DOWNROD INTO THE MOTOR COUPLING AND LOCK THE ASSEMBLY
Prepare for fan installation as follows:
Step A. Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
Step B. Using th e provid ed allen wrench, loosen the set scr ew
several turns to allow installation of the downrod. Thread
the downrod into the motor coupling until it stops turning,
this will take at least four and a half full turns.
Step C. Securely tighten th e set screw with the provi ded allen
wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the do wnrod before secur ely tightening the allen set
screw may cause the fan to separate from
the downrod during normal operation!
DOWNROD & BALL
ASSEMBLY
MOTOR
WIRES
GROUND
WIRE
DOWNROD
& BALL
ASSEMBLY
TAPERED
THREAD
ALLEN
SET SCREW
MOTOR
COUPLING
CEILING HARDWARE
CROSSBAR
MOUNTING
BRACKET
WIRE NUT (4)
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
If you do not have an existin g fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Warning: To reduce the risk of fire , electrical shock,
or personal injury, mount to outlet box marked acceptable for ceiling fan support, using the mounting
hardware provided with the outlet box.
3
ADDITIONAL HARDWARE
1
2
/
″ x 8-32 ROUND HEAD
4
SCREWS (2)
1″ x 8-32 ROUND
HEAD SCREWS (2)
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (eith er circuit breaker
or fuse box), lower the old fixture an d disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is
marked ‘Approved for ceiling f an mounting’. If it is not, a new
box must be installed.
FLAT WASHER (2)
CROSSBAR MOUNTING BRACKET INSTALLATION
Proceed with installation as follows:
Step 1. Route the wires from th e ceilin g outlet bo x thr ough
the crossbar moun ting bracket center h ole. Attach th e bracket,
with ground wire an d ridges d own, to the ceiling fixtur e outlet box with the moun ting hard ware includ ed with the outlet
box.
Tighten the screws firmly by hand only, be careful not to
bend the bracket by over tightening.
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware pr ovided with
the approved outlet bo x to install
the crossbar mounting bracket.
CEILING FAN
APPROVED
OUTLET BOX
CEILING
WIRING
CROSSBAR
MOUNTING
BRACKET
WASHER
FLAT
STEALTH
®
RIDGE
SIDE
DOWN
GREEN
GROUND
WIRE
OUTLET BOX
MOUNTING
HARDWARE
CANOPY/BLADE HARDWARE/GLASS
CANOPY SCREW (4)
CANOPY
HATCH
CANOPY
CANOPY
LOCK WASHER (4)
CANOPY INSTALLATION
Step 2. Attach the canopy to th e cross bar with thr ee o f the
8-32 x 2
against the ceiling. On sloped ceilin gs, align the canopy opening toward the top or peak o f th e room. Your Casablanca fan
may be installed on a vaulted or cathedral ceiling in the
same manner as described for a flat ceiling. The Hang-Tru
mounting system m akes it possible to han g your fan on ceilings sloped up to a 32° angle.
1
/2″ long canopy scr ews an d hand tigh ten until sn ug
Note: On sloped ceilings, align the
canopy opening towards the top or
room peak.
CROSSBAR MOUNTING
BRACKET INSTALLED
®
TRUSS HEAD
BLADE SCREW
(4 PER BLADE)
FIBER WASHER
(4 PER BLADE)
CANOPY
CANOPY LOCK
WASHERS
GLASS
HALOGEN BULB
CANOPY
SCREWS
4
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.