![](/html/0c/0c23/0c239b60f1c29243a0608a724debb179d02772703c2ddef3c98d2322a0be78c2/bg1.png)
Your Cart-Tek golf caddy was thoroughly quality control checked and road
tested before being shipped to your address. We do everything possible to
assure that your cart is in perfect working order upon arrival. Should you
have any issues or questions about the performance or your cart, please email
us at carttek@mac.com or call Toll Free 1-866-356-CART (2278)
![](/html/0c/0c23/0c239b60f1c29243a0608a724debb179d02772703c2ddef3c98d2322a0be78c2/bg2.png)
BASIC SETBASIC SET--UPUP
Remove all components form carton. Note any damage with carrier.
Assemble the two large wheels. Depress blade on wheel hub to fully seat wheel onto axle drive
pins. Depress and pull wheel out ¼ “ to “free wheel”
Lift handle and secure with lower locking knob
Extend handle fully and secure in position by lowering the “upper bag rest”
Place battery in tray and use small block of wood to hold battery “forward” in the tray. Attach
power cable, making sure to align pins. Depress lock before removing cable.
Attach rear “anti-tip” wheel
Load golf bag onto caddy. Attach bag straps using the metal latches
Attach antenna to command center.
There are two spare fused packed with your cart. You should carry these in your golf bag. In
case of ‘power loss’, check the fuse in the battery case first.
1.) Lift handle into upright position
2.) Lower locking knob 3.) Lower upper bag rest
to lock handle in position
![](/html/0c/0c23/0c239b60f1c29243a0608a724debb179d02772703c2ddef3c98d2322a0be78c2/bg3.png)
Manual ModeManual Mode
When you first connect the battery to the cart, the green LED will flash. This is
“Standby” mode
Push and hold on/off button until the green LED is solid
Rotate speed dial clockwise to control speed of cart.
Rotate speed dial counter-clockwise to slow/ stop cart’s motion
.) when light turns steadily red, caused by
standby LED
2.) Speed
Controls
3.) On/off
button
.) when light turns steadily red, caused by
voltage. Ways to fix this problem;
press Emergency stop on remote or press
stop button on receiver
b.) when red light is flashing rapidly, caused
by over-current. Ways to fix this problem;
press emergency stop on remote to stop
the cart. When the red light flashes for
more then 25 seconds the cart will
automatically stop.
c.) when red light is flashing slowly caused
by high temperature. Ways to fix problem;
turn off cart and allow battery to cool
down.