Carter-Hoffmann TE SERIES, TN SERIES, TL SERIES General Manual

Page 1
Cleaning, Operating, Maintenance Instructions, Parts List & Warranty
Stubborn spots
Apply with damp sponge or cloth. Rub in direction of polish lines. Rinse
1.
Tray slide assemblies are easily removed without tools for cleaning;
1.
For best
results insert loaded tray in cart as quickly as possible. Doors
Enclosed Tray Delivery Carts
Series: TE, TL & TN
NOTE:
This equipment has been designed and manu­factured to meet all applicable health and safety codes and will give years of dependable service if used properly. All carts should be thoroughly cleaned before using.
Cleaning Instructions
simply lift up and pull out. The tray slides may be hand washed or run through an automatic washer.
CAUTION:
Cleansers, detergents, degreasers, sanitizers, or bleaching agents that contain chlorides or phosphates will cause permanent damage to stain­less steel products. The damage appears as pits, eruptions, voids, small holes, cracks, severe discol­oration, or dulling of the finish of the metal. THIS DAMAGE IS PERMANENT, COSTLY TO REPAIR, AND IS NOT COVERED BY THE WARRANTY.
2. To clean stainless steel surfaces use only cleansers, detergents, degreasers, or sanitizers that are certified to be "chloride-free" and "phosphate-free," and cleansers, degreasers, or sanitizers only in the recommended concentrations. DO NOT exceed recommended concentrations or mixing ratios. After cleaning and sanitizing, rinse all exposed surfaces thoroughly with large amounts of clear water. Wipe off any standing liquid or residue from all horizontal surfaces in corners, or near edges.
3. Vinyl trim should be washed with a chlorine-free detergent and water. Rinse thoroughly with clear water and allow to dry. Never use abrasive cleaners, waxes, car polish or substances containing strong aromatic solvents or alcohol. Caution: When using solvents, it is essential that proper precautionary measures be observed. Refer to solvent manu­facturer's instructions. Use of direct steam/hot water cleaning at temperatures above 190°F may result in "bubbling" or loosening of vinyl adhesive.
RECOMMENDED "TIPS" FOR CLEANING STAINLESS STEEL
Purpose Frequency Cleaning Agent Method of Application Routine
cleaning Smears/
fingerprints
Daily Soap, ammonia detergent and
water
As Needed Stainless steel cleaner or similar
products
Sponge with cloth, rinse with clear water and wipe dry.
Rub with cloth as directed on package. Rub in direction of grain of stainless steel. Do not use on vinyl trim.
and stains
Hard water spots
Daily As Needed Any chloride-free or phosphate-
free cleaner
Daily As Needed Vinegar Swab with cloth. Rinse with water and wipe dry.
CAUTION: Do not use steel wool pads as they will result in rusting from the ferrous metal in the pads.
Operating Instructions
thoroughly after use, especially if cleaner contains chlorine bleach. Do not use on vinyl trim.
should be opened only when necessary in order to help keep foods at proper temperature and prevent contamination of foods from outside sources.
2. Take care to avoid bumping carts into doors, walls, obstructions, etc.
Page 2
[A]
DOORS
Maintenance
Instructions
Replacement
Part Number
Description
Contact Factory for: Gray Vinyl Perimeter Bumper Vinyl
IM PORTANT:
Carter
-
Hoffmann
Warranty Exclusions
Carter-Hoffmann Corporation (CARTER
-
HOFFMANN) warrants to the initial purchaser of Us standard Car
ter line
1-1450-0000-695
CAUTION:
Never move cart unless all doors are securely closed. Serious damage to hinges and doors may result if bumped into table, walls or other equipment when doors are open.
Never tip carts forward or open doors to drain water during or after washing. This can cause serious damage to hinges, doors, and latches.
[B] LATCHES
Check frequently to insure that all door latches are secure. Latches may become "sticky" due to residue buildup from daily use and cleaning. Lubricate latches regularly with WD-40, silicone spray, graphite or other commercial lubricants for stainless steel products. Do not use oil.
[C] HINGES
Your cart doors and hinges have been factory aligned with nylon spacers to assure positive latching and smooth action. Be sure to replace these washers if they are removed when cleaning doors and hinges. If doors are removed for cleaning, we recommend that they be put back on the same cart to assure the best possible alignment and operation.
[D] CASTERS
Some casters are equipped with zerk grease fitting so that they may be easily lubricated with a grease gun. Recommended lubrication is at least once every six months. Lubrication will be required at least every two weeks if carts are cleaned with a hot water or steam cleaning system. Casters with special bearings are recommended for frequent cart wash or steam cleaning situations.
[E] PERIMETER BUMPERS
Vinyl which has been dislodged from the channel due to severe bumping or scraping can be pried back into place with a common screwdriver.
Parts
Corporation Warranty:
And Limitations:
18302-0190 Sliding Latch
Door Trim (Specify Model Number and Serial Number)
Products that CARTER-HOVF MANN will. at ifs option, repair or replace, during the warranty period set forth below, any part of such products made necessary due to a defect in material or workmanship which is present when the product leaves its fac tor}' and which manifests itself during the warrant}' period under normal use and service. This warrant}' applies only to original equipment owned and possessed by the initial purchaser and the warrant}' period begins on the date of original shipment from the (1ARTEK-HOFFM'\NN factory and extends as follows: to
electrical and refrigeration components for one year: to electrical and refrigeration labor for 120 days; to refrigeration compressor unit for 1 year {limited to replacement of the unit only}—not to include labor for
removal, repair or replacement), and to all other component parts and labor for 12 months. Repair or replacements under this warranty it'll/ he performed, unless otherwise authorized in writing by (CARTER­HOFFMANN at its factory. All parts or components to be repaired or replaced under this warranty are to he shipped
prepaid to (CARTER-HOFFMANN with reimbursement credit for such part or component to he given if found by CAKTEK-HOPFMANN to be defective. CARTFM-HOFFMANN neither makes nor as sumes and does not authorize any other person to make or assume any allegation or liability in connection with its products other than that covered in this warranty. This warranty applies only within the continental United States and Canada. In Alaska and Hawaii, this warranty applies only to and is limited to the supply of replacement parts.
Any implied warranty of ' merchantability or fitness for a particular purpose is hereby specifically disclaimed hy Carter-Hoffmann Corporation. There are no warranties, expressed or implied, which extend beyond the description on the face hereof. This warranty does not cover and CAHTER-HOFFMANNN shall not under any circumstances be liable for any incidental, consequential or other damages (such as injury to persons or properly, loss of lime, inconvenience, loss of use, loss of business or profits, or other matter not specifically covered) arising in connection with the use of, inability to use. or failure of these products.
Specifications subject to change through product improvement and innovation. Printed
When ordering parts be sure to include model number, serial number and
approximate date of purchase.
in U.S.A.
1551 McCormick Avenue, Mundelein, Illinois 60060 Tel. (847) 362-5500 • Fax No. (847) 367-8981
Loading...