Carter Hoffman CC232 Parts List

Cleaning, Operating, Maintenance Instructions, Parts List & Warranty

1.

Before cleaning, unplug unit.

For Standard Carts Model CC232,
CC345, CC460, CC576, CC688, and
CC Refrigerated Series

NOTE:

This equipment has been designed and
manufactured to meet all applicable health and
safety codes and will give years of dependable
service if used properly. This cart should he
thoroughly cleaned before it is used.

Cleaning Instructions

All heaters and refrig­erators should not
be exposed to direct

WARNING contact with water or
cleaning sprays. Permanent damage to
the electrical components will result.

Cleaners, detergents

degreasers, sanitizers,
or bleaching agents

CAUTION that contain chlorides

or phosphates will cause permanent

damage to stainless steel products.

The damage appears as pits, eruptions,

voids, small holes, cracks, severe discol-

oration, or dulling of the metal finish.

Water with high chloride content can

also damage stainless steel. If unsure

of your water quality, we recommend

you have it tested. THIS DAMAGE IS

PERMANENT, COSTLY TO REPAIR,

IS NOT COVERED BY THE

2. If required, remove tray racks. The tray racks may be hand washed or
run through an automatic washer.

3. Vinyl trim should be washed with a chlorine-free detergent and water.
Rinse thoroughly with clear water and allow to dry. Never use abrasive
cleaners, waxes, car polish, or substances containing strong aromatic
solvents or alcohol.

4. To clean stainless steel surfaces use only cleansers, detergents,
degreasers, or sanitizers that are certified to be "chloride-free" and
"phosphate-free," and cleansers, degreasers, or sanitizers only in the
recommended concentrations. DO NOT exceed recommended
concentrations or mixing ratios. After cleaning and sanitizing, rinse ^ all
exposed surfaces thoroughly with large amounts of clear water. Wipe off
any standing liquid or residue from all horizontal surfaces in corners, or
near edges.

Purpose Frequency Cleaning Agent Method of Application

Routine Daily Soap, ammonia detergent Sponge with cloth, rinse with clear water and wipe dry.
cleaning
Smears/ As Needed Vista, Stainless Shine or Rub with cloth as directed on package. Rub in direction

fingerprints
Stubborn Daily Household cleaners or Apply with damp sponge or cloth. Rub in direction of polish
spots and As Needed Goddards Stainless Steel lines. Rinse thoroughly after use, especially if cleaner
stains

Hard water Daily Vinegar Swab with cloth. Rinse with water and wipe dry.
spots As Needed

RECOMMENDED "TIPS" FOR CLEANING STAINLESS STEEL

CAUTION: Do not use steel wool pads as they will result in rusting from the ferrous metal in the pads.

and water

similar products of grain of stainless steel. Do not use on vinyl trim.

Care. Revere Stainless contains chlorine bleach. Do not use on vinyl trim.
Cleaner or similar products.

Cabinet
Operations

NOTE:

If you wish to use water in the heat
wells, be sure to use hot water and
cover the wells during pre -heat.

These units are designed to hold
food at the proper serving
temperature only.

Be sure that hot foods are at or
above the desired serving
temperatures.
Be sure that chilled foods are at
or below the desired serving
temperature.

1. Connect the unit's power cord to the correct power source and
energize.

A. Heated Servers:

Turn the appropriate heat well thermostat to number 7. A

red indicator lamp beside the thermostat will come on and
stay on until the proper temperature is re ached.

B. Refrigerated Servers:
Turn the "ON-OFF" switch on; a red lamp within the switch will
come on.

2. Allow 30-45 minutes for the unit to come to proper holding temperature:

-about 160°F for heat wells

-about 36°F to 40°F tor refrigerated units.

3. Once the unit has reached proper temperature, quickly place food

items into the servers.

4. After serving, turn off heaters and/or refrigerators. Drain off any excess

water and remove any frost buildup.

THERMOSTAT CALIBRATION

If additional heat range is required in the heating unit, unplug unit,
remove black thermostat knob, insert small straight blade screwdriver
into opening and turn limit control set screw counter clockwise one full
turn. Replace thermostat knob and turn clockwise to reach new
maximum temperature. Repeat this until desired temperature is reached.
Each 1/4 turn of the calibration set screw will raise the element heating
capacity by approximately 25 -35 degrees.

If a reduction of heat is desired, turn limit control set screw clockwise
one full turn. Hold the door open allowing unit to cool until inside
temperature is below the temperature desired . Close the door and allow
unit to rise to new maximum temperature. Repeat this until desired
temperature is reached.

CASTERS

Maintenance
Instructions

Vinyl which has been dislodged from the channel due to severe bumping
or scraping can be pried back into place with a common screwdriver.

Some casters are equipped with Zerk grease fitting so that they may be
easily lubricated with a grease gun. Recommended lubrication is at least
once every six months. Lubrication will be required more frequently if
carts are cleaned with a hot water or steam cleaning system. Casters
with special bearings are recommended for frequent cart wash or steam
cleaning situations.

LATCHES

Check frequently to insure that all door latches are secure. Latches may
become "sticky" due to residue buildup from daily use and cleaning.
Lubricate latches regularly with WD-40, silicone spray, graphite or other
commercial lubricants for stainless steel products. Do not use oil.

PERIMETER BUMPERS

2

Replacement Parts

CC345

CARTS:

Part Number Description
18600-0070 Thermostat
18608-0010 Thermostat Knob
18611 -0080 Heat Well 1000w, 110v
18611 -0070 Heat Well 1000w, 220v
18611-0075 Heat Well w/Drain 1000w, 220v
18612-0260 Heat Element 1000w, 220v
18601-1150 Red Pilot Light
18602-0030 Toggle Switch
18602-0010 Canopy Switch
18602-0055 Lighted Switch 120 volts
18602-0056 Lighted Switch 220 volts
18614-0010 Pressure Control Switch

Wiring Diagram

CARTS:

CC232

Part Number Description______________________
18601 -1406 40 watt To ugh Skin Lamp
27080-0010 FH80 Heater for Base Units
18308-0010 Drop Down Tray Slide Bracket

18308-0015 Drop Down Tray Slide Bracket
(Stainless Steel)

29034-0160 Breaker Strip (CC -MFL/FL)
18412-1112 S.S. Bi-Fold Lid (10" x 20")

18412-1111 S.S. Bi-Fold Lid (20" x 20")
(for CC-60-MFL)
18309-0050 6" Adjustable Legs (set of 4)

3

(Chrome Plated, Die Cast)

(for CC-45-FL, CC-60-MFL)

Carter-Hoffmann Corporation Warranty:

Carter-Hoffmann Corporation ("CARTER-HOFFMANN") warrants to the initial purchaser of its standard Carter Line Products that
CARTER-HOFFMANN will, at its option, repair or replace, during the warranty period set forth below, any part of such products
made necessary due to a defect in material or workmanship which is present when the product leaves its factory and which
manifests itself during the warranty period under normal use and service.

This warranty applies only to original equipment owned and possessed by the initial purchaser and the warranty period begins on
the date of original shipment from the CARTER-HOFFMANN factory and extends as follows: to electrical and refrigeration
components for one year; to electrical and refrigeration labor for 120 days; to refrigeration compressor unit for I year (limited to
replacement of the unit only—not to include labor for removal, repair or replacement), and to all other component parts and labor
for 12 months.

Repair or replacements under this warranty will beperformed, unless otherwise authorized in writing by CARTER-HOFFMANN, at
its factory. All parts or components to be repaired or replaced under this warranty are to be shipped prepaid to CARTER­HOFFMANN, with reimbursement credit for such part or component to begiven if found by CARTER- HOFFMANN to he defective.

CARTER-HOFFMANN neither makes nor assumes and does not authorize any other person to make or assume any obligation
or liability in connection with its products other than that covered in this warranty. This warranty applies only within the
continental United States and Canada. In Alaska and Hawaii, this warranty applies only to and is limited to the supply of
replacement parts.

Warranty Exclusions And Limitations:

Any implied warranty of merchantability or fitness for a particular purpose is hereby specifically disclaimed by Carter -Hoffmann

Corporation. There are no warranties, expressed or implied, which extend beyond the description on the face hereof.
This warranty does not cover and CARTER-HOFFMANN shall not under any circumstances he liable for any incidental,
consequential or other damages (such as injury to persons or property, loss of time, inconvenience, loss of use, loss of business
or profits, or other matters not specifically covered) arising in connection with the use of, inability to use, or failure of these
products.

Specifications subject to change through product improvement and innovation.

Printed in U.S.A.

1551 McCormick Avenue, Mundelein, Illinois 60060
Tel. [phone] • Fax No. [phone]

18400-3018

SN/96P1733