Car Show DS-TY0710 Installation Manual
Installation Guide
* JBL Audio equipped vehicles will require additional part # DP-TYJBL1 audio interface.
NOTICE OF INTENDED INSTALLATION AND USE
THE CAR SHOW MULTI-MEDIA NAVIGATION SYSTEMS CONTAIN AN INTERNAL VIDEO PLAYER, WHICH
IS NOT INTENDED FOR VIEWING BY THE DRIVER. THE VIDEO PLAYER IS DISABLED WHEN THE
VEHICLE IS IN MOTION THROUGH A CONNECTION TO THE PARKING BRAKE.
THE INSTALLER OF THIS PRODUCT MUST INSURE THE VIDEO DISABLE CONNECTION IS
WORKING PROPERLY PRIOR TO DELIVERY OF THE VEHICLE.
IMPROPER INSTALLATION COULD DISTRACT THE DRIVER OR INTERFERE WITH SAFE OPERATION
OF THE VEHICLE, WHICH COULD RESULT IN SERIOUS INJURY OR DEATH, AND COULD ALSO
VIOLATE STATE AND/ OR FEDERAL LAW.
CAR SHOW DISCLAIMS ANY LIABILITY FOR ANY BODILY INJURY OR PROPERTY DAMAGE THAT MAY
RESULT FROM ANY IMPROPER OR UNINTENDED INSTALLATION AND/OR USE.
CAUTION
Observe safe practices, this process can be dangerous and
DS-TY0710 Toyota Camry
STOP
Damage to the vehicle may occur
Do not proceed until process has been completed
CAUTION
Process must be carefully observed in order to reduce the
risk of damage to the accessory or vehicle
CRITICAL
Process must be carefully observed in order to ensure a
quality installation
TOOLS and EQUIPMENT
Specific tools and equipment recommended for this
process
SAFETY RISK
there is a risk of personal injury
TESTING and TROUBLESHOOTING
Content specific testing and troubleshooting points
Car Show Entertainment Systems Copyright 2012 All Rights Reserved
Multi-Media Navigation System Installation Guide Rev A
Car Show Installation Guide
PREPARING FOR THE INSTALLATION
Before you start, please read these critical steps below
STEP
1
BEFORE YOU START THE INSTALLATION,
READ THIS GUIDE!
CHECK THE BATTERY
Test the battery voltage to make sure it’s fully charged to a
minimum of 12.8 VDC
This only takes seconds and can save hours of
troubleshooting later.
TURN THE VEHICLE
OFF
Keep the Vehicle Off during the installation to avoid setting
various Vehicle Fault sensors
Keep the Vehicle OFF during the
installation
Failure to follow this may cause the AIRBAG FAULT
SENSOR to become enabled. Dealer Service Departments
charge a significant fee to reset the Fault Sensor.
Car Show Copyright 2012 All Rights Reserved
Installation Guide
Page 2
Car Show Installation Guide
REMOVE THE FACTORY RADIO
*JBL Audio equipped vehicles will require additional part # DP-TYJBL1 audio interface
You will need to remove multiple interior trim components prior to removing the factory radio.
The following steps will help guide you through this process.
Carefully Remove Lower Dash Trim
Components
Use Caution, the plastic is fragile and excess force can
break or damage trim
STEP
2
CAUTION
Carefully Remove Lower Dash Trim
Components
Use Caution, the plastic is fragile and excess force can
break or damage trim.
Remove Upper Vent Trim
Use thin pry tool to carefully remove vent trim
Unplug Electrical Connections
Carefully unplug harness from back of vent assembly
CAUTION
Remove mounting screws
Remove 4 x 10mm bolts to remove radio
Car Show Copyright 2012 All Rights Reserved
Installation Guide
Page 3
Loading...