Carrier TSTATCCREC01, TSTATBBREC01, P474-1100REC Installation Instructions Manual
Installation Instructions
TSTATCCREC01
TSTATBBREC01
P474-1100REC
NOTE: Read the entire instruction manual before starting the installation.
POWER
MULTI-STAGE WIRELESS RECIEVER
HEAT
COOL
FAN
Wireless Reciever
HEAT
COOL
&
HEAT
PUMP
Form: IM-TSTAT-10
Cancels: Printed in U.S.A.
Catalog No. 13TS-TA36
Table Of Contents
PREPARATION
REMOVE OLD THERMOSTAT
MOUNT WALL PLATE & WIRE
CONNECTIONS & SWITCHES
WIRING DIAGRAMS
CALABRATION
TROUBLESHOOTING
CAUTION
Follow Installation Instructions carefully.
DISCONNECT POWER TO THE HEATER AIR CONDITIONER BEFORE REMOVING
THE OLD THERMOSTAT AND INSTALLING
THE NEW THERMOSTAT.
This receiver is designed to operate @
0-70 C
FCC ID MUH-T10016
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
WARNING
2
3
4
5
7
10
11
Page 1
STEP #1
12:00
Cool
70
Set
Fan Auto
70
MODE
FAN
12:00
Cool
70
Set
Fan Auto
70
MODE
FAN
PREPARATION
Proper installation of the receiver will be
accomplished by following these step
by step instructions. If you are unsure
about any of these steps, call a qualified
technician for assistance.
Assemble tools as shown below.
Flat Blade
Screwdriver
12:00
Cool
70
Set
Fan Auto
70
MODE
FAN
Make sure your Heater/Air Conditioner
Wire cutter
& Stripper
is working properly before beginning
installation of the receiver.
12:00
Cool
70
Set
Fan Auto
70
MODE
FAN
Carefully unpack the receiver.
Save the screws, wall anchors, and
instructions.
Page 2
Drill with
3/16 inch
Drill Bit
STEP #2
12:00
Cool
70
Set
Fan Auto
70
MODE
FAN
12:00
Cool
70
Set
Fan Auto
70
MODE
FAN
12:00
Cool
70
Set
Fan Auto
70
MODE
FAN
12:00
Cool
70
Set
Fan Auto
70
MODE
FAN
12:00
Cool
70
Set
Fan Auto
70
MODE
FAN
REMOVE OLD THERMOSTAT
Turn off the power to the Heating/Air
Conditioning system at the main fuse
panel. Most residential systems have
a separate breaker for disconnecting
power to the furnace.
Remove the cover of the old thermostat.
If it does not come off easily check for
screws.
Loosen the screws holding the thermostat
base or subbase to the wall, and lift away.
Disconnect the wires from the old
thermostat. Tape the ends of the wires
as you disconnect them, and mark them
with the letter of the terminal for easy
reconnecting to the receiver.
Keep the old thermostat for reference
purposes, until your new thermostat is
functioning properly.
Page 3
Loading...