Carrier TSTATCCPB101, TSTATBBPB101 Installation Instructions Manual

Installation Instructions

TSTATCCPB101
TSTATBBPB101
P474-1010

Digital Thermostat

NOTE: Re_d _ an_r_ kmauc_n n_kU Ee_oee iqllhv_ the ir_*ab_n.

0

HEAT

COOL

&

HEAT

PUMP

MULTI-STAGE• SINGLEDAYPROGRAMMABLE

Fonlt IM-TSTAT_7 Can_: _ in U_. _ NO-13T_TA43

PREPARATION 2
REMOVE OLD THERMOSTAT 3

INSTALL BACKPLATE & WIRE 4
WIRING DIAGRAMS 5
CALIBRATION 8

TEST OPERATION 9

TROUBLESHOOTING 10

CAUTION Followlnstallotlonlnsln_tion_carefully.

[_SCONNECT POWER TO THE HEATER -
AIRCONDITIONER BEFORE REMOVING

THEOLD THERMOSTATAND INSTALLING

THENEW THERMOSTAT. WARNING

Replacement Components Division _) Carder Corporation 4/01

This device complies with Part 15 ofthe FCC rules.

Operation is subject to the following2 conditions:

(1) This device may not cause harmful interference,
and (2) This device must accept any interference

received, including interference that may cause
undesired operation.

Fogel

@
@

@

Proper installation of the thermostat will be
accomplished by following these step

by step instructions. If you are unsure

about any of these steps, call a qualified
technician for assistance.

Assemble tools as shown below.

Flat B/ade
Screwdriver

Wire cutter (when not using

& Stripper j-box)

Make sure your Heater/Air Conditioner

is working properly before beginning
installation of the thermostat.

@

Carefully unpack the thermostat.
Save the screws, wall anchors, and

instructions.

Page 2

@

@
@

Turn off the power to the Heating/Air
Conditioning system at the main fuse

panel. Most residential systems have

a separate breaker for disconnecting

power to the furnace.

Remove the cover of the old thermostat.
If it does not come off easily check for

screws.

Loosen the screws holding the thermostat

base or subbase to the wall, and lift away.

@

@

Disconnect the wires from the old
thermostat. Tape the ends of the wires

as you disconnect them, and mark them
with the letter of the terminal for easy

reconnection to the new thermostat.

Keep the old thermostat for reference

purposes, until your new thermostat is

functioning properly.

Poge3