Thehumidifieroperatesin conjunctionwith thefurnace blowermotor.When
the humidistatcallsfor humidityandthe blower motorisoperating,water flows
tothe distributionpanlocated atthetop ofthe unit.Thewater is uniformlydis-
tributedacrossthe width ofthe panandthrough ascientificallydesignedsystem
of outlets.It flows bygravityoverthe humidifierpad.Dry,hotairis moved
throughthe moisture-ladenhumidifierpadwhereevaporationtakesplace.The
now-humidifiedair carriesmoistureinvapor formthroughoutthe home.
Thecorrect water flow is determinedby an orifice in each unit.When the
unit is operating,therewill be a small, steadystreamofwater to drain, which
flushesaway mostofthe trouble-causingminerals. Donot use the saddle valve
to regulate the water flow. It is designed to be completely opened or closed.
The minerals and solid residue not trapped by the replaceable humidifier pad
are flushed down the drain. The drain also eliminates the problems caused by
stagnant water. This is the most effective and least expensive methodto dispose
of trouble-causing minerals.
Trouble-free performance and minimum maintenance are assured by the
design features of the humidifier. All unit housing parts that come in contact with
water are non-metal and will never rust or corrode. Neither heat nor water will
affect them under normal operating conditions.
The humidifier pad, designed especially for uniform, high evaporation, and
the Scale Control Insert also efficiently trap mineral deposits which are often the
cause of damage to working parts in ordinary humidifiers. No "white dust" can
be distributed throughout the living quarters. The humidifier pad must be in good
condition to assure high capacity trouble-free performance. It should be
changed annually.
Older design water distribution trays have a granular coating in the bottom of
the distribution tray to provide equal distribution of water to each of the openings
assuring an even flow over the humidifier pad. Do notcleanthe mineral scale off
the bottomofthe water distributiontray at the end ofthe humidificationseason.
If the granular coating is removed, it is not necessary to purchase a new distri-
bution tray. You can accomplish the same uniform performance by applying a
small amount of liquid dishwashing soap over the entire inside surface of the
water distribution tray. This will allow the water to flow evenly through each of
the openings, provided the unit is level, in order to achieve maximum capacity.
The current distribution tray which incorporates a synthetic fabric liner that
replaces the granular coating, is designed to deliver water uniformly over the
entire top surface of the humidifier pad, provided it is mounted level. It is normal
for some mineral deposits to form in the distribution tray as it dries out between
humidification cycles. These deposits can actually help distribute water in the
tray, but if they form enough to block the openings, they should be removed as
described in the "Periodic Preventative Maintenance" section of this manual.