Carrier 38QHF036, 38QHF025, 38QHF050, 38QHF060, 38QHF065 Installation Manual

900x315x860

590333

Right rear side
refrigerant pipe
hole 65φ

Left rear side
refrigerant
pipe hole 65φ

Indoor unit outline

45

42QHF025 :(A:800, B:275, C:100, D:95)

A

C

D

B

Right rear side
refrigerant pipe
hole 65φ

Left rear side
refrigerant
pipe hole 65φ

Indoor unit outline

45

A

C

D

B

42QHF036 / 42QHF050: (A:940, B:275, C:110, D:100)

Right rear side
refrigerant pipe
hole 65φ

Left rear side
refrigerant
pipe hole 65φ

Installation plate

A

21.5

C

D

B

45

42QHF060 / 42QHF065 : (A:1045, B:315, C:293, D:163)

Air freshening filter(1)

(used to install onAir filter)

6

Right rear side
refrigerant pipe
hole 65φ

Left rear side
refrigerant
pipe hole 65φ

Indoor unit
outline

C

389

A

B

52

52

332

D

Indoor unit outline

42QHF080: (A:1259, B:362, C:172, D:257)

810x310x558

U

20cm or more

700x240x540

Model

38QHF025

38QHF036 / 38QHF050

845x320x700

38QHF060

38QHF065 / 38QHF080

The holes for fixing anchors should be 5mm.

Power supply from outdoor

Power
supply

W 1 2(N ) S

W 1 2(N ) S L N

Do not p ut drai n
end into water

Connection diagrams

Use a vacuum pump to evacuate air from the
system until 76cmHg, do the reakage check before
remove the charge hose.

Fully open the packed valve stem before test
operation, use some leak detector or some soap
water to check the refrigerant line connections.

Wire cross section is depending on the rated (max) current which is indicated as below:

Rated (max) current of appliance (A)

11. 5QHF025 / QHF036

12.5QHF050

14.5QHF060 / QHF065

16.0QHF080

For a ll QHF fa mily

1.Lift the indoor unit front panel.

2.Remove the indoor unit electrical cover and cord clamp by loosening the screws.

3.Pass the connecting wires from the back of indoor unit and connect to the indoor terminal block.

1. Remove the electrical cover and cord clamp by loosening the screws.

2. Connect wires to the outdoor terminal block by same sequence to indoor unit.

Press the ON/OFF button on remote control
to begin testing.

Press MODE button, select COOL, HEAT, FAN
mode to check if all functions work correctly.

Press the manual button once to energize
the unit.

When ambient temperature is lower than 17 ,
the unit can not be controlled by remote
control to run in cooling mode. For this
condition, manual operation must be used.

Open front panel of the indoor unit;

Model