Carr XRS Rota Installation Instructions Manual

Installation Instructions for Carr XRS Rota Light Bar - Black Powder Coat (07-16 Wrangler JK)

Installation Time: 30-50 Minutes

Tools Required:

 Ratchet
 Torque bits (8mm)
 Allen wrenches 3/16”

All bolts and smaller pieces that are included

Bracket Mount with all parts for assembly (Same for both sides minus Torque bits *not included)

Cross Bar

I did not tighten everything down until the very end to ensure proper fit. I also did most of the assembly inside BEFORE
mounting them to my 08 Jeep Jk. Also ensure the side mounts are not interfering with the door when opening during final
phase.

Installation Instructions:

1. Instruction one: I started by assembling the left side of the mount first (or right side) by placing the 3/8” bolt and

washer into the Rota Square Casting, and secured the Rota Hood Casting to the Welded Nut.

2. Then secure the Mounting End Bracket to the Rota Square Casting (and the rest of the assembly) by using the

1/4 “socket bolts & Nylon washers and screwing them into the Rota square casting.