Carnes SJEB 1205 User Manual

Imperial [IP] Dimensions

Metric (SI) in Parenthese

SPECIFICATION SHEET

MODEL SJEB

ROUND NECK STAMPED LOUVERED DIFFUSER

ADJUSTABLE—SURFACE MOUNT

CARNES COMPANY, 448 S. Main St., P. O. Box 930040, Verona, WI 53593-0040 Phone [phone] Fax: [phone] [e-mail]

CARNES COMPANY © 2008 COPYRIGHT

ALL RIGHTS RESERVED

SUPERSEDES 12006-A 12006-B

Nominal Surface Number

Duct Size of

Model (Dia.) A B C D E Cones

SJEB 1205 5 (127) 12-1/2 (318) 4-7/8 (124) 3 (76) 3-1/4 (83) 1-1/4 (32) 2
SJEB 1206 6 (152) 12-1/2 (318) 5-7/8 (149) 3 (76) 3-1/4 (83) 1-1/4 (32) 2
SJEB 1208 8 (203) 12-1/2 (318) 7-7/8 (200) 3 (76) 3-1/4 (83) 1-1/4 (32) 2
SJEB 2406 6 (152) 24-1/2 (622) 5-7/8 (149) 4-1/2 (114) 5-3/16 (132) 1-1/4 (32) 3
SJEB 2407 7 (178) 24-1/2 (622) 6-7/8 (175) 4-1/2 (114) 5-3/16 (132) 1-1/4 (32) 3
SJEB 2408 8 (203) 24-1/2 (622) 7-7/8 (200) 4-1/2 (114) 5-3/16 (132) 1-1/4 (32) 3
SJEB 2410 10 (254) 24-1/2 (622) 9-7/8 (251) 4-1/2 (114) 5-3/16 (132) 1-1/4 (32) 3
SJEB 2412 12 (305) 24-1/2 (622) 11-7/8 (302) 4-1/2 (114) 5-3/16 (132) 1-1/4 (32) 3
SJEB 2414 14 (356) 24-1/2 (622) 13-7/8 (252) 4-1/2 (114) 5-3/16 (132) 1-1/4 (32) 3

DIMENSIONS LISTED IN INCHES

NOTES: 1. The inner assembly is easily removable by compressing the locking spring and rotating counter clockwise.

2. To gain access for damper adjustment, remove the plug button on the center core of the inner assembly.

3. Horizontal to vertical air pattern adjustment is made by changing the position of the inner assembly on size 12 and
adjusting the pattern deflectors on size 24.

4. Standard finish is #11 White Electrocoat Enamel.

A Square

MINIMUM CEILING SQUARE

OPENING IS “A” MINUS 1-1/4 (32)

B

Dia. Outside

E

C

D*

* “D” DIMENSIONS SHOWN FOR SJEB 12 IS
VERTICAL PATTERN FOR HORIZONTAL ADD
5/8” (16).

Vertical Throw

Horizontal Throw

SIZE 24

Vertical Throw

Horizontal Throw

SIZE 12

SIZE 12

VERTICAL POSITION

THROW

HORIZONTAL POSITION

THROW