Carlson Wireless Technologies I-WLL-T Users Manual

CARLSON WIRELESS TECHNOLOGIES, Inc.

CARLSON WIRELESS USA

USA Headquarters:

1180-B Evergreen Road

P.O. Box 2400

Redway, CA 95560 USA

Tel: [phone]

Fax: [phone]

Email [e-mail]

URL http://www.wireless-telephone.com

About Carlson Wireless Technologies Inc.

Carlson Wireless Technologies, Inc. was formed in March
1999 as a privately held corporation based in Redway, Cali­fornia. Carlson Wireless Technologies (CWT) is dedicated to
designing, manufacturing and marketing state-of-the-art digi­tal WLL (wireless local loop) telephone systems that provide
high-quality voice and data for rural and remote telephone
users worldwide. CWT was founded by James Carlson fol­lowing a 15-month product development by a team of engi­neers at Carlson Engineering Services (CES),. In 1999 CWT
purchased the rights to the digital wireless telephone system
designed by CES. CWT will market and manufacture the
product, which has been named "The i-WLL Internet-Ready,
All-Digital Wireless Remote Telephone Link."
CWT is marketing the i-WLL product through established
telecom and wireless equipment distributors. Please contact
our sales department [phone], or sales@wireless­telephone.com for more information.

DISTRIBUTED BY:

Trailblazer with Integral Antenna

INSTALLATION and USERS MANUAL for

Model i-WLL– T Trailblazer 2 Line

Caution! - Please read the sections on
Unpacking, Planning, and Installation be­fore installing this equipment

Carlson Wireless USA revision 2.12 Page 16

Carlson Wireless USA revision 2.12 Page 1

TABLE OF CONTENTS

SCOPE OF MANUAL

R.F. SAFETY HAZARD WARNING
UNPACKING
PRODUCT OVERVIEW
SYSTEM PLANNING
INSTALLATION
TROUBLESHOOTING
SPECIFICATIONS
COMPLIANCE INFORMATION
WARRANTY

i-WLL, the i-WLL logo , Trailblazer, the Trailblazer logo, Carlson Wire­less USA, and the Carlson Wireless logo are registered trademarks of
Carlson Wireless Telephone Inc. Any trademarks, trade names, ser­vice marks, or service names owned or registered by any other com­pany and used in this manual are the property of their respective
companies. Copyright 1999, 2000, Carlson Wireless Technologies
Inc. All rights reserved.

3
3
3
4
5
8
11
12
14
15

Carlson Wireless USA Limited Warranty

Carlson Wireless Technologies (CWT) or Carlson Wireless USA, Col­lectively referred to as "Carlson“) will repair this product with new or
rebuilt parts, free of charge, in the USA or Puerto Rico for two (2) years
from the date of original purchase in the event of a defect in material or
workmanship. Mail-in service in the USA can be obtained during the
warranty period from a Carlson Factory Service center by calling +1­707-923 4736, for a RMA (Return Materials Authorization) number and
mail your product adequately packed, postage paid and insured to the
address provided. This warranty is extended only to the original pur­chaser. A purchase receipt or other proof of date of original purchase
will be required before warranty performance is rendered. This war­ranty only covers failures due to defects in materials or workmanship
which occur during normal use. It does not cover damage which occurs
in shipment or failures which are caused by products not supplied by
Carlson or failures which result from accident, misuse, abuse, neglect,
mishandling, misapplication, alteration. modification, lightning, line
power surge, introduction of sand, dust, humidity and liquids or com­mercial use of the product, or service by anyone other than a Carlson
Factory Service center or authorized Carlson Service center, or dam­age that is attributable to acts of God.

Limits and Exclusions

There are no express warranties except as listed above.
CARLSON SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSE­QUENTIAL DAMAGES RESULTING FROM THE USE OF THIS
PRODUCT, OR ARISING OUT OF ANY BREACH OF THIS WAR­RANTY. ALL EXPRESS AND IMPLIED WARRANTIES, INCLUDING
THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, ARE LIMITED TO THE APPLICABLE
WARRANTY PERIOD SET FORTH ABOVE.

Some states do not allow the exclusion or limitation of incidental or
consequential damages, or limitations on how long an implied war­ranty lasts, so the above exclusions or limitations may not apply to
you. This warranty gives you specific legal rights and you may also
have other rights which vary from state to state. If a problem with this
product develops during or after the warranty period you may contact
your dealer or Service center. If the problem is not handled to your sat­isfaction, fax, phone, or write the company at the address indicated in
the service section of this manual.

Carlson Wireless USA revision 2.12 Page 2

Carlson Wireless USA revision 2.12 Page 15

Compliance and US Regulatory Information

Connection to the Telephone Network

The equipment complies with Part 68 of the FCC rules. You will find the
label located on the device. This label contains the FCC Registration
Number and the Ringer Equivalence Number ((REN) for this equipment.
You must, upon request, provide this information to your telephone com­pany.

The REN is useful to determine the quantity of devices you may connect
to your telephone line and still have all of those devices ring when you
telephone number is called. In most, but not all, areas, the sum of the
REN’s of all devices connected to one line should not exceed five (5.0).
To be certain of the number of devices you may connect to your tele­phone line , as determined by the REN, you should call your local tele­phone company to determine the maximum REN for your calling area.

Incidence of Harm

If your telephone equipment cause harm to the telephone network, the
telephone company may disconnect your service temporarily. If possible,
they will notify you in advance. But if advance notice is not practical, you
will be notified as soon as possible. You will be informed of your right to
file a compliant with the FCC.

Rights of the Telephone Company

Your telephone company may make change in its facilities, equipment,
operations or procedures that could affect the proper functioning of your
equipment. If they do, you will be notified in advance to give you an op­portunity to maintain uninterrupted telephone service.

Coin Service or Party Use Line

This equipment may not be used on the coin service provided by the tele­phone company. Connection to party lines is subject to state tariffs.

SCOPE OF MANUAL

This manual is designed to support the installation, operation and mainte­nance of the i-WLL–Trailblazer All-Digital Remote Wireless Telephone
Link. To avoid harm to persons or damage to the product please ensure
that you have read through the unpacking and installation sections before

R.F. SAFETY HAZARD WARNING

This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment when installed as directed.
This equipment should be installed and operated with fix-mounted
antennas that are installed with a minimum of 2 meters of
separation between the antenna and all persons body during normal
operation.

UNPACKING

The i-WLL-Trailblazer system will arrive in one box approximately 19 x
15x 13 inches (47 x 37 x 32 cm). Small amounts of feed cable and/or
power supplies may also be included in this box if ordered.

Caution! Observe static precautions when wiring or handling circuit
boards. We provide secondary lightening protection only. Unless your
feed cable is very short (less than 50 ft total) you will need a primary gas
discharge type lightening protector also. At the office side of connection
your telephone provider should have installed a primary protector.

There are nylon standoffs holding the antenna element to the reflector
plate. These are fragile and can easily be over-tightened. They are set to
a specific torque and if over-tightened may fail.

Radio interference

Carlson Wireless USA Model: i-WLL-Trailblazer

This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful in­terference, and (2) This device must accept any interference received,
including interference that may cause undesired operation. Changes of
modification not expressly approved by the party responsible for compli-

ance could void the user’s authority to operate the equipment.

Carlson Wireless USA revision 2.12 Page 14

Carlson Wireless USA revision 2.12 Page 3