Carlon HS4317D Instruction Manual

INSTRUCTION GUIDE

Key Pad Entry Alarm – HS4317D
ENCLOSED YOU WILL FIND:

• Key Pad Entry Alarm

• Magnet

• Double-sided tape

• Optional screws

TOOLS NEEDED:

• Small Phillips head screwdriver

BATTERIES NEEDED (not included):

• Three “AAA” alkaline batteries

INSTALLATION

For indoor use only. You must mount the alarm and magnet so the magnet rests
with its arrow pointing toward one of the alarm’s markings for proper alignment.
Choose a location that lets you install the magnet on a door or window and the
alarm next to it on the frame or vice versa. The distance between the alarm and
the magnet must be no more than 5/16 inch. Use the supplied screws or the
supplied adhesive tape and follow these steps to mount the alarm and magnet.

1. Remove the screw on the bottom of the alarm and remove the back cover.

2. Use two screws or two of the pieces of supplied adhesive tape to mount the
back cover. If using tape, make sure mounting surfaces are free of dust, oil and
other substances that could affect adhesion.

3. Install 3 “AAA” alkaline batteries onto appropriate terminals.

4. Slide the alarm onto the back cover.

5. Replace the screw on the bottom of the alarm.

6. Use the two remaining screws or the other piece of the supplied adhesive tape
to mount the magnet so the arrow points toward one of the markings on either
side of the alarm.

SETTING THE SECURITY CODE

You can set your own four-digit alarm security code.

• Your alarm’s security code is preset to 1234 at the factory. Be sure you use a
different security code.

• You must enter all four numbers within 10 seconds, or the red indicator turns off
and the alarm exits the procedure and resets to the previous security code.

• If you remove the battery, the security code resets to 1234.

Follow these steps to set your own security code.

1. Press keys 3 and 4 at the same time. The red indicator lights.

2. Enter the current security code. The yellow indicator flashes.
Note: If this is the first time you are setting the code, enter 1234.

3. Enter the desired four-digit code. The yellow indicator will flash once and a short
beep will sound to indicate a security code change.

ARMING/DISARMING

When the unit is powered up, two beeps will sound and then the unit will be in the
off mode. The unit can be turned on by pressing the keys 1 and 2 at the same
time. A beep will sound indicating the unit is armed. The unit can be turned off by
pressing the keys 1 and 2 at the same time. Two beeps will sound indicating the
unit is disarmed. To change between chime and alarm mode, the unit has to be
turned off first and set to the desired mode. Then turn on the unit.

1. Chime Mode

Simply set the mode switch to ”chime” and turn on the unit. The electronic chimes
sound when someone opens the door. If not, readjust the position of the magnet.

2. Alarm Mode

Set the alarm’s mode switch to ”instant” or “delay” and turn on the unit. Then close
the door. A beep will sound to indicate the unit is armed.
Note: If you don’t close the door within about 30 seconds, a continuous beeping
sound will alert you that the door is not closed. You can only turn off the beeping
sound by closing the door.

The alarm sounds when someone opens the door. In delay mode, you will have
about 10 seconds to enter the security code before the alarm sounds. In instant
mode, the alarm will sound instantly for about 60 seconds or until you enter the
security code.
Note: After about 60 seconds, the alarm automatically shuts off and is armed
again. The green indicator will flash to indicate there was an intrusion.
Note: You cannot silence the alarm by pressing the keys 1 and 2 at the same time.
You must enter the security code or wait about 60 seconds for the alarm to stop
sounding.

BATTERY REPLACEMENT

If one of the following conditions occurs, replace the batteries:

• The red LED flashes and a short beep sounds every 20 seconds

• The chimes’ or alarm’s sound becomes weak

• The alarm does not work at all when the door opens

Note: For longer battery life, use alkaline batteries. If the alarm does not respond
after you replace the battery, remove the battery and reinstall it. Each time you
remove the battery, the security code resets to 1234.

LIMITED WARRANTY

The product you have purchased is guaranteed against defects in workmanship
and materials for the period stated on the package. Warranties implied by law are
subject to the same time period limitation. Some states do not allow limitations on
how long an implied warranty lasts, so this time limitation may not apply to you.

If the product fails due to a manufacturing defect during normal use, return the
product and dated sales receipt to the store where purchased for replacement OR
send the product and the dated sales receipt to:

Lamson & Sessions

Attn: LHP Customer Service

25701 Science Park Drive

Cleveland, OH 44122 USA

Not Covered - Batteries, light bulbs, and other expendable items are not covered

by this warranty. Repair service, adjustment and calibration due to misuse, abuse
or negligence are not covered by this warranty. Unauthorized service or
modification of the product or of any furnished components will void this warranty
in its entirety. This warranty does not include reimbursement for inconvenience,
installation, set-up time, loss of use, postage, unauthorized service, or other
products used in conjunction with, but are not supplied by, Lamson & Sessions.

All requests for replacement must include a dated sales receipt (copies accepted).
LAMSON & SESSIONS IS NOT LIABLE FOR LOST PROFITS, INDIRECT, SPECIAL,
EXEMPLARY, INCIDENTAL OR CONSEQUENTIAL DAMAGES INCLUDING WITHOUT
LIMITATION ANY SUCH DAMAGES DUE TO IMPROPER WIRING OR MISUSE OF THE
PRODUCT. As some states do not allow the exclusion or limitation of incidental or
consequential damages, the above limitation and exclusion may not apply to you.

ALSO AVAILABLE FROM CARLON:

• Extend-A-Chime®– lets you hear your existing wired doorbell in remote areas
of your home or yard

• Plug-in and Battery Doorbells and Chimes

• On/Off Remote Switches

• Touch and Automatic Lighting Controls

This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.

25701 Science Park Drive
Cleveland, Ohio 44122
www.lamson-sessions.com

Made in China
©2007

071024 IS137