Carlon E-Loc User Manual

Gross Automation (877) 268-3700 · www.carlonsales.com · sales@grossautomation.com
INSTALLATION INSTRUCTIONS FOR E-LOC COUPLINGS
1. Check and make sure sizing of fitting is same as the conduit/innerduct
being installed. E-LOC® couplings are based on standard IPS nominal outside diameters.
2. Wipe spigot end of conduit/innerduct clean. Make sure it is clean of burrs,
3. The spigot end of the conduit/innerduct can be lubricated with water or
water with a small amount of liquid dishwashing soap. (Do not use motor
oil or thread lubricants commonly used for metal pipe threads. This includes W-D 40 “type” lubricant.)
4. On smaller diameter conduit/innerduct, position fitting on the duct – place
a board across the end and hit with a small mallet or hammer. (Do not hit the fitting directly with the hammer.) On larger diameter conduit, clean
®
and lubricate spigot as above. Put a 3” mark on spigots of 4” and larger conduit/innerduct to make sure the fitting is “home”. Use a bar and block to push the joint. If a hammer and block of wood are used, make sure wood is in contact with both sides of the fitting and hit block center. (Do not hit the fitting directly with the hammer.) Check to be sure that the fitting is all the way “home” onto the conduit/innerduct.
5. When joining conduit/innerduct off a reel, install E-LOC® coupling on the
plain end coming from the reel using steps #1 through #4 above. After the coupling is installed properly, clean the spigot of the other conduit/innerduct and push onto spigot end of the conduit/innerduct. If necessary, place a small board on the edge of the coupling toward the reel and drive the coupling onto the conduit/innerduct. (Do not hit the fitting directly with the hammer.)
www.carlonsales.com
Loading...