Carlo Gavazzi RGC1S, RGS1S Catalog Page
Solid State Relays
1-Phase with Integrated Current Monitoring
Types RGC1S, RGS1S
• Product width ranging from 22.5mm to 70mm
• Available with or without integrated heatsink
• Partial load failure detection
• Zero cross switching
Ratings up to 600VACrms & 85AACrms @ 40
•
• Up to 6600A
• Control voltage range : 4 - 32 VDC
• Local or remote current set-point
• LED indications for the different faults
• Alarm signal output for SSR or load circuit malfunction
• IP20 protection
• Integrated voltage transient protection with varistor
• RoHS compliant
Short circuit current rating 100kArms
•
2
s for I2t and 1200Vp for blocking voltage
o
C
Product Description
This slim RG design is capable
of detecting various failure
modes occuring to the heaters
and also to the product itself.
Failures which can be detected
include partial load failure,
heater loss, open circuit SSR,
short circuit SSR and SSR
over temperature. A normally
closed, potential free alarm,
opens in the event of a system
or power semiconductor fault.
A load current setpint has to be
TEACHed to the SSR either
locally by the TEACH button
Note: Specifications stated at 25°C unless specified.
on the front of the device or
remotely through the provided
terminal.
This product is available either
with integrated heatsink
(RGC1S series) and also without heatsink (RGS1S series).
The minimum product width is
22.5mm. The control and auxiliary terminals are double box
clamps to facilitate safe looping whilst the power terminals
are either screw terminals or
box clamps depending on the
model selected.
Ordering Key
RGC 1 S 60 D 30 G K E P _
Solid state relay
Number of poles
Switching mode
Rated operational voltage
Control voltage
Rated operational current
Connection type for control
Connection type for power
Connection configuration
Protection
Options
Ordering Key
1-Phase Switching Rated V, Control Rated current1@ 40˚C Connection Connection Connection Protection
SSR mode Blocking V* voltage I2t data input output configuration
RGC1: S: Zero 60:600VAC D: 4-32VDC 20: 23AAC, 525A2s G: Box K: Screw E: Contactor P: Over-
with heatsink cross with +10% -15%, 25: 23AAC, 1800A
RGS1: current 1200Vp 30: 30AAC, 1800A2s Clamp protection
with no heatsink sensing 31: 30AAC, 6600A
41: 40AAC, 6600A2s
61: 60AAC, 6600A2s
90: 85AAC, 6600A2s
2
s Clamp G: Box U: SSR temperature
2
s
* Rated voltage, Blocking voltage
1: refer to derating curves for RGC models and heatsink selection tables for RGS models
Specifications are subject to change without notice (18.03.2013) 1
Loading...