Carl Martin Hydra boost User Manual

Manual

Imagine you solo with an extra few dB's on top to get it
where it belong, or maybe boost you're input on your amp
to get more sustain and bite, or simply drive you're distor­tion pedals with extreme input for extraordinary distortion.

FEATURING
Low noise design * 15 dB clean boost * Input Impedance
240K * Output impedance 150 Ohm
9V battery adapter * Rugged housing * Vintage style poin

­ter knob * High bright blue LED
Performance and headroom can be improved by using 12
& 18V power supply.

HYDRA BOOST

ECHO

DRIVE

HYDRA BOOST

Place the HYDRA BOOST last in you're pedal set-up, to boost up you're solo without boost the
pedals in front of it.

Beef up you're amp with the HYDRA BOOST, set the amp gain as high as possible just before
it begin to overdrive, then boost you're input on your amp with the HYDRA to get more sustain
and bite, and control the overall level on the master volume.

Boost you're overdrive pedals with extreme input for extraordinary overdrive, place the HYDRA
BOOST first before the overdrive pedal, use and set the overdrive to you're normal rhythm
tone, then boost the input on the overdrive. It will not necessarily give higher volume, but it will
give much more sustain and drive, all depending on the setting on the HYDRA.

ECHO

DRIVE

HYDRA BOOST

Warranty: Carl Martin Research warrants the manufacturing, material and proper operation for a period of one
year from date of purchase. Carl Martin will replace defective parts, make necessary repairs or replace the
unit at the discression of our technicians. The warranty applies only to the original purchaser of this product,
and excludes any damage or faulty operation resulting from misuse, neglect or unauthorized service.

HandMade in Denmark
East Sound Research Raadmandsvej 24 8500 Grenaa Denmark Phone: [phone]
E-Mail: [e-mail]

Specifications

Input……..........……........ 240 KOhm

Output………………........ 150 Ohm

S/N Ratio......................... 80dB

Frequency range............. 40hZ-16kHz

Boost............................... + 15dB

Dimensions ..................... 110 (W) x 65 (D) x 50 (H) mm

4.32” (W) x 2.55” (D) x 1.96” (H)

Weight.............................. 220g / 0,49lbs

Power Requirements

Battery: The Hydra Boost requires a 9V battery. To
replace the battery, carefully remove the back panel by
loosening and removing the 4 screws, install the new
battery and then re-install the back panel.
Power consumption: max. 10 mA
Power supply: 9 V DC (regulated), 50 mA minimum, 2.1
mm female plug, center negative (-)
ATTENTION: Please Use DC Power Supply Only!
Failure to do so may damage the unit and void the
warranty.