manual contour
General Guidelines on the use of the Contour & Boost:
Carl Martin Contour & Boost
is especially designed to boost up, and change the sound (contour) of electric guitar/bass.
The Contour & Boost circuitry is of phase linear design, using high quality components. This ensures sonic clarity and
midrange emphasis which is so important for electric guitar.
The Contour & Boost is designed as a High Pass (low cut) and Low Pass (high cut) filter, with a fixed X-over frequency
at 440Hz. The High Pass filter operates from 65Hz to 440Hz, and the Low Pass filter from 440Hz to 8kHz. Both filters are
individually sweepable, with a boost range of up to 12dB. With these two filters it is possible to change the sound
(contour) in any way your creativity allows you.
The Contour & Boost has a built in, regulated (+-12V) power supply which enables us to design circuitry of the highest
quality with maximum headroom. Please note that when using this unit with other effect devices, always place the
Contour & Boost after any distortion units, otherwise the distortion unit will limit what you can achieve w ith the Contour &
Boost.
The Contour & Boost has shown to be very suitable for direct recording on tape or PC, just set it up like this: GUITAR to
EFFECTS to CONTOUR & BOOST to LINE DRIVER and into the desk or PC, try out with the suggested sample setting
and work your way from there.
SAMPLE SETTINGS:
V
SPECIFICATIONS:
http://www.carlmartin.com/manual_contour.htm (1 of 2) [5/15/2007 8:48:29 AM]
manual contour
Power:
Power consumption:
S/N ratio:
Input impedance:
Output impedance:
THD distortion:
Frequency range:
High pass range:
Low pass range:
Boost range:
Dimension:
Weight:
100 or 115 or 230 VAC 50-60Hz
2,4 Watts
80 dB
1M Ohm
100 Ohm
0,01% at 0 dB
65 Hz - 8 kHz
65 Hz to 440 Hz
440 Hz to 8kHz
+12 dB
120(D) 95(W) 77(H)
0,625Kg
http://www.carlmartin.com/manual_contour.htm (2 of 2) [5/15/2007 8:48:29 AM]