Carlisle OPTIMIZER ADD6, OPTIMIZER ADD4 Assembly & Instruction Manual

OPTIMIZER™ ADJUSTABLE DISH DOLLY

ASSEMBLY INSTRUCTIONS

P.O. Box 53006
Oklahoma City, Oklahoma 73152-3006
[phone] • FAX [phone]
1-800-654-8210
Web Site: www.carlislefsp.com
#104803213 - 1/05

European Distribution Center:
Edisonstraat 84, P.O. Box 110
6900 AC Zevenaar, The Netherlands
Tel [phone] • Telex 45642
FAX [phone]

1. Following the layout for the size of plate/platter that you are using (see the back of this page),
place a divider (with the bolt on the bottom) into one of the slots (see Figure 1). In order to
secure the plates/platters properly, make sure the divider is facing the correct way shown in the
layout (see other side).

2. Place a single plate/platter between the divider and the wall of the dish dolly (see Figure 2).

3. Reaching under the cart, place a washer and knob onto the divider bolt and twist a few turns (see
Figure 1). While pushing the bottom of the divider lightly against the plate/platter, turn the knob
until the divider is tight (see Figure 2).

4. Repeat steps 1 through 3 for each of the remaining stack positions illustrated in the layout.

5. Fill each position with plates/platters.

Many other combinations can be created when combining
different size plates/platters. For these combinations,
follow these steps:

1. Determine the best layout by placing plates/platters in
the dolly and placing dividers loosely in the slots. Move
the plates/platters and dividers around to create the best
fit. Usually, the divider will be turned so that the wider
side of the divider is against the plate/platter.

2. After determining the best layout, secure the dividers as
in step 3 above.

3. Fill each position with plates/platters.

PRODUCT NUMBERS: ADD4 & ADD6

Figure 2

Figure 1
cutaway showing slot

ADD4 Layout for

9-7/8" to 10-5/8" plates

OPTIMIZER™ ADJUSTABLE DISH DOLLY

ASSEMBLY INSTRUCTIONS

P.O. Box 53006
Oklahoma City, Oklahoma 73152-3006
[phone] • FAX [phone]
1-800-654-8210
Web Site: www.carlislefsp.com
#104803213 - 1/05

The following diagrams show the standard layouts for plates from 5-1/2” to 12-1/2” and platters
from 9-1/2” by 7-1/4” to 13-1/2” by 10-1/2”. Locate the desired plate/platter size(s) in the ranges
below each layout. Many other options are available if different plate/platter sizes are used together
(see the bottom of the instructions on the other side of this page).

NOTE: When setting up the dish dolly, be sure to turn the dividers as indicated in each layout.

Layout for 11-3/8" to

12-1/2" plates and 13-1/2" by

10-1/2" platters

Layout for 10-3/4" to

11-1/4" plates

Layout for 9-7/8"

to 10-5/8" plates

Layout for 8-3/8" to

9-3/4" plates

Layout for 12" by 9-1/4" to

9-1/2" by 7-1/4" platters

Layout for 8" to

8-1/4" plates

Layout w/2 Additional Dividers

for 5-1/2" to 7-7/8" plates

European Distribution Center:
Edisonstraat 84, P.O. Box 110
6900 AC Zevenaar, The Netherlands
Tel [phone] • Telex 45642
FAX [phone]