Carex B651, B652 Assembly Instructions Manual
Assembly Instructions
Bath and Shower Seat with Back
Leg Extensions x 4
Backrest x 1
B651/B652
Seat x 1
L Bars x 2
Washer x 5
U Bar x 2
Labeled “1”
and “2”
Medium Screws x 1
Long Screws x 4
2
1
2
1
Place seat face down on a table or counter
1
with the seat lip near the edge of the table.
Place U bar labled “1” on the groove in the seat
so the “1” on the bar is next to the “1” on the
seat.
Place the U bar labled “2” on the seat so the “2”
on the bar is next to the “2” on the seat.
Carex Health Brands
PO Box 2526, Sioux Falls, SD 57101-2526
Phone 800.526.8051 www.carex.com
2
2
1
1
Find the 1 medium sized screw - Warning
2
- medium screw must be used for the next
step or damage to the seat will occur.
Place medium screw with washer into center hole
through both U bars and into the screw hole in the
seat.
Contour of washers should match curve of bar.
Made in China
42-B65100_10 ©2014
Assembly Instructions
LARGE SCREWS
Bath and Shower Seat
2
2
1
1
Attach backrest to both L bars.
3
Press in the pop pins and line
up with backrest holes. Assure pins are
completely through the holes.
5
Slip leg extensions
on, push copper pin
and slide on, line
up pin and hole so
pin pops through
leg extension hole
completely.
Repeat for all 4
legs.
Adjust height so all
legs are the same
height.
Place L bar over U bar holes so holes line up.
4
Screw in using long screws - include washer.
Do not tighten yet.
Repeat with other L Bar. Tighten the 4 long screws.
Tighten the middle medium screw. Periodically check
to assure that all screws remain tight.
6
Check for stability.
Assure all pins are
completely through
the holes and legs
are all the same
height.
Place Bath and
Shower Bench in
shower or bath.
Periodically check
to assure that all
screws remain tight.
Loading...