Page 1
MG15 Auto-Lock Gate
ASSEMBLY INSTRUCTIONS
FOR OPENINGS 26” (66cm) - 40” (102cm)
A
B
C
1
6 ”
3
D
F
E
G
H
I
J
2
A
C
1. Install hinge
bracket (A) to wall
(stationary side of
gate) using Phillips
screw (C)
beginning 6 ”
above floor
surface.
D
C
B
2. Install second
screw (C) in
top of hinge
bracket
securing it to
the wall.
4
2X
REPEAT AT
BOTTOM OF
THIS SIDE OF GATE HAS THREE (3) HOLES
3.
Insert eye bolts (D) into top and bottom
of hinge side gate (side with three holes).
Be sure nuts are tight.
5
J
G
GATE
LOOSEN AT TOP AND
BOTTOM OF GATE TO
ADJUST GATE WIDTH
2X
E
H
4.
Hang gate by inserting hinge rod (B), through top of mounted
hinge bracket (A), through upper plastic shoulder washer (E),
through both eye bolts, through lower plastic shoulder washer
(E), and finally through bottom of hinge bracket. To secure
hinge rod, insert key ring (H) through hole in end of hinge rod.
6
G
C
•”
4X
MOUNT LATCH
ASSEMBLY WITH
SCREWS
5. Set gate to width by holding latch assembly against
mounting wall (see beginning of STEP 6). Use Allen
wrench
and bottom of gate.
(F) to insert set screws (
ONE-WAY
STOP BRACKET
Install one-way stop bracket (I)
on one
open in only one direction.
side of latch to have gate
CHILDREN HAVE DIED OR BEEN SERIOUSLY INJURED WHEN GATES ARE NOT SECURELY INSTALLED. ALWAYS INSTALL AND USE GATES
AS DIRECTED USING ALL REQUIRED PARTS. STOP USING WHEN A CHILD CAN CLIMB OVER OR DISLODGE THE GATE. USE ONLY WITH
THE LATCHING MECHANSISM SECURELY ENGAGED. NEVER USE TO KEEP CHILD AWAY FROM POOL.
J) and tighten top
I
6. Hold latch assembly (G) against opposite
wall and extend gate until at least ” of
safety bracket will interlock with flange
of latch. Mark position of latch assembly
screw holes with penci
of way and mount latch assembly to wall.
Check closure of gate and tighten set
screws from STEP 5 to secure gate width.
GATE IS RECOMMENDED FOR
CHILDREN UP TO 24 MONTHS.
l. Swing gate out
Page 2
GATE OPERATION
NOV 2018
FOR OPENING:
STEP ONE: Lift latch
hook with finger.
STEP TWO: Twist
latch in direction
desired to open gate.
STEP THREE: Leave
latch open.
1
2
FOR CLOSING:
Simply push
gate back into
latch assembly
from the
direction
opened until a
“click” sound
is heard.
GATE MAINTENANCE
When used outdoors we suggest spraying hinge and latch parts with a marine corrosion inhibitor
by CRC or equivalent. This can be obtained normally at marinas or auto parts stores. Remove set
screws when separating frames for cleaning.
To clean, rinse with lukewarm water, wash gently with mild soap or detergent and lukewarm water,
using a soft cloth or sponge. Rinse again. Dry with a soft cloth or sponge to prevent water spotting.
DO NOT SCRUB or use brushes or squeegees.
GATE CARE & REMINDERS
At CARDINAL GATES, INC., we design what we believe to be the very best, and most user
friendly gates available. Our gates are built to last many years with proper use and care. Here
are a few suggestions...
• Clo se gates gently - do not slam - to prevent damage to latch me chanis m.
• When closing, be sure safety bracket on gate frame engages as depicted in instructions.
• For safety, always close gate when not in use. Children should not be allowed to swing on an
open gate as this can damage hinge mount.
• Keep allen wrench in a secure place. We suggest removing set screws when separating sections
for cleaning. Periodically check all screws, bolts, etc. for security and proper adjustment.
CARDINAL GATES, INC., offers many accessories such as extensions, stair kits, and other
safety products. Check with your deale
We sincerely hope that you thoroughly enjoy many years of service from your CARDINAL GATE.
r or call CARDINAL GATES, INC. at 1-800-318-3380.
GATE WARRANTY
Your Cardinal Gate is warranted to be free of manufacturing defects for a period of one year
from the date of purchase when used in homes, and according to manufacturers instructions.
When used commer cially, such as day car e center s, the war ran ty is 90 days.
Cardinal Gates, lnc. will either repair or replace, at our option, any parts necessary to correct
defects in material or workmanship during the warranty per
for incidental, special and consequential damages of any nature.
iod. The warranty disclaims liabilty
TO EXERCISE WARRANTY:
Ship your gate in a protective carton, freight prepaid to:
CARDINAL GATES, INC.
79 Amlajack Way
Newnan, GA 30265
You must include the following:
1. Proof of purchase (store receipt, etc.).
2. Brief note describing problem with gate.
3. Full return address along with phone number.
FOR FURTHER ASSISTANCE
Call 1-800-318-3380
79 Amlajack Way
Newnan, GA 30265
770-252-4200
www.cardinalgates.com
Loading...