Page 1
Version 12.08
.20 10
AUX - 110
AUX-In Interface
AUX-101
Audi MMI 2G HIGH
Information
Changes/updates of the vehicle’s software can cause malfunctions of the interface. We
offer free software-updates for our interfaces for one year after purchase. To receive a free
update, the interface must be sent in at own cost. Labor cost for and other expenses
involved with the software-updates will not be refunded.
1. Prior to installation
Read the manual prior to installation. Technical knowledge is necessary for installation. The
place of installation must be free of moisture and away from heat sources.
1.1. Delivery contents
AUX - 101
HW_____ SW_____
Take down the SW
-
version and HW
-
version of the interface
boxes,
and store this manual for support purposes.
Page 2
Version 12.08
.20 10
AUX - 110
1.2. Check compatibility of vehicle and accessories
Requirements
Navigation/Radio Audi MMI 2G High
Limitations
Factory CD-changer One factory CD-changer can be installed additionally.
2. Installation
Switch off ignition and disconnect the vehicle’s battery!
The interface needs a permanent 12V source. If power source is not taken directly from
the battery, the connection has to be checked for being start-up proven and permanent.
2.1. Vehicle selection (blue wire)
For installation on Audi blue wire is not connected and needs to be isolated.
2.2. Installation example Audi MMI 2G High
Remove MOST®-connector from the rear of the
factory CD changer and integrate Interface
according to schema. Obey arrows one the
MOST®-connectors as well as the order of
components.
Connect black wire to ground and red wire to
permanent +12V. Isolate blue wire.
Page 3
Version 12.08
.20 10
AUX - 110
3. Operation
The AUX-110 emulates a factory CD-changer and is recognized as such by the head-unit. The
AUX-input is activated by playing CD1 on the head-unit.
Note: On Audi with one factory CD-changer
installed, the AUX-101 emulates a second factory
CD-changer. Play CD7 to activate AUX-input.
4. Specifications
Operation voltage
10.5
– 14.8V
Stand
-
by power drain
<1mA
Operation power drain 120mA
Power consumption 1.8W
Temperature range -30°C bis +80°C
Weight
95g
Measurements (box only) B x H x T 106 x 30 x 71 mm
5. Technical Support
Caraudio
-
Systems Vertriebs GmbH
NavLinkz GmbH
manufacturer/distribution
corporate sales/tech support
Rheinhorststr. 22
Eurotec
-
Ring 45
D-67071 Ludwigshafen am Rhein
D-
47445 Moers
phone +49 180 3 907050 email
support@caraudio-systems.de
Legal disclaimer: Mentioned company and trademarks, as well as product names/codes are registered
trademarks ® of their corresponding legal owners.
Loading...