Caratec CAV224DS User Manual

Caratec Vision

CAV224DS

User‘s Manual

Contents

Contents

Safety Information

OSD Menu

1. Picture menu

2. Sound menu

3. Channel menu

4. Feature menu

DVD Operation

1-3

4

11-19

11
12
13-16
17-18
19

24-31

Product Introduction

5

Connections

Remote Control

Basic Operation

6-7

10

Multimedia Operation 20-22

EPG menu 23

5. Setup menu

8-9

AUTO INSTALLATION

Safety Information

1

Safty Information

2

Safety Information

IMPORTANT SAFETY INFORMATION (Continued)

This unit has been produced according to all current safety regulations. The following safety

tips should safeguard users against careless use and the dangers connected with such use.

Although this appliance has been carefully manufactured and rigorously checked

prior leaving the factory, as with all electrical appliances it is possible for problems to
develop. If you notice smoke, an excessive build up of heat or any other unexpected
phenomena, you should disconnect the plug from the mains power socket
immediately.

Ensure that the unit is sufficiently ventilated! Never place next to or underneath

curtains!
The mains plug or appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operarble.

This set should only be connected to a mains power supply which matches that

stated on the label on the rear of the TV – do not attempt to connect it to any other

type of supply.
The socket – outlet must be installed near the equipment and easily accessible.
To prevent overload, don’t share the same mains supply socket with too many other

items of equipment.
Apparatus with Class 1 construction shall be connected to a mains socket outlet with

a protective earthing connection.
Keep away from rodents. Rodents enjoy biting into electric flexes.
Always hold the plug when pulling out the plug from the mains supply socket. Do not

pull on the flex, the flex can become overloaded and cause a short circuit.

Set up the unit so that no one is able to trip over the flex.
Do not place heavy items on the flex, which may damage it.

Take note that the flex cannot be reached and pulled by young children, avoiding

injury.

Do not set up the unit near to heat sources. The casing and the flex could be

damaged by the impact of heat.

The screen is made of plastic and can break if damage is done to it. Be careful when

collecting sharp edged plastic splinters to avoid injury.

Avoid placing the unit on any surfaces that may be subject to vibrations or shocks.
To protect the unit during a thunderstorm unplug the AC power cable and disconnect

the aerial. Caution: Do not touch the aerial (RF) connector.

When you leave your home for long periods of time, unplug the AC power cable for

safety reasons.

The unit becomes warm when in operation. Do not place any covers or blankets on

the unit in order to prevent overheating. The ventilation holes are not to be blocked.
Do not set up near radiators. Do not place in direct sunshine. When placing on a
shelf leave 5 cm (2”) free space around the whole unit.

Do not allow water or moisture to enter the TV. Do NOT use in wet or moist areas

such as Bathrooms, steamy kitchens or near swimming pools.

Do not use this unit when moisture condensation may occur
Any repairs must be carried out by qualified personnel only.
Do not open this unit. A non – expert attempting to repair the unit could be dangerous

and potentially cause a fire hazard.

Safety Information

Safety Information

Safety Information

3

IMPORTANT SAFETY INFORMATION (continued)

Liquids spilt into the unit can cause serious damage. Switch the set OFF and

disconnect the mains power supply, then consult a qualified service person before
attempting to use the unit again.

Do NOT remove the safety covers. There are no useable or serviceable parts inside.

You may invalidate the warranty. Qualified personnel must only service this
apperatus.

Do NOT tap or shake the screen, you may damage the internal circuits. Take good

care of the remote control, do not drop.
Never place hot objects or open flame sources on or close to the TV.
High temperatures can melt plastic and lead to fires.

Where to install

Locate the television away from direct sunlight and strong lights, soft indirect lighting is
recommended for comfortable viewing. Use curtains or blinds to prevent direct sunlight
falling on the screen. Place the TV on a sturdy platform of which the surface should be flat
and steady. This will prevent it from falling over.
Make sure the television is located in a position where it cannot be pushed or hit by objects,
as pressure will break or damage the screen, and so that small objects cannot be inserted
into the ventilation slots or openings in the cabinet.

Headphone Warning

Loud music can damage your hearing irreversibly, therefore do not set the volume to a high
level when listening through headphones,

particularly for lengthy listening periods.

To clean the TV use a soft dry cloth. Do NOT use solvents or petrol based fluids. For

stubborn stains, you may use a damp cloth with dilute detergent.

Product Introduction

Product Introduction

4

Front View

LED indicator Remote Control window(keep clear)

The functions of the TV buttons are described below.

MENU: Press to display the OSD menu, Press again to exit the menu.
CH+/CH-: Press to scan through channels.

They are also can be used to move down/up in the OSD menu screen.
VOL+/VOL-: Press to adjust the volume.
They are also can be used to move left/right in the OSD menu screen.

VOL+ button can be used to skip forward to next menu.

INPUT: Press to select the source.

POWER: Turn on/off the TV set.

PLAY: Play/pause the disc playing.
EJECT: Eject the disc.

Die bedruckte Seite der Disc muss zur Gehäuserückseite zeigen

Connections

Connections

5

RF: Connect antenna or cable 75 Ohm coaxial to receive TV signal.

POWER: Connect to the mains adaptor.

HDMI: Connect it to the HDMI of DVD or other equipment.

VGA: For PC display.Connect it to the D-Sub 15 pins analog output connector of the PC.

PC-IN: Connect it to the audio output terminal of PC.

SCART: Connect them to the SCART video output terminal of DVD.

Coax:

Digital output to AV receiver.

MINI AV: Connect it to the audio & video output terminal of DVD with the Converter cable.

(Audio terminals are shared with YPbPr)

MINI YPbPr: Connect it to the YPbPr video output terminal of DVD with the Converter cable.

USB: Connect to USB device for multimedia

DVB-S2: Connect a Satellite signal.
Common Interface: CI slot.

POWER HDMI VGA PC-IN SCART RF COAX

Common Interface HeadphoneDVB-S2USB

YPbPr

MINI

AV

MINI

Headphone: Connect it to your headphone or other audio equipment.

Main Power Switch
To switch on/off the TV

Remote Control

6

Remote Control

The remote control is using Infra-Red(IR). Point it towards the front of the LED TV. The remote
control may not work correctly if it is operated out of range or out of angle.

POWER MUTE

PICTURE ASPECT SOUND

SLEEPSUBTITLE

CH.LIST

123

456

789

0

VOL CH

INPUTDISPLAY

EPG

TV/RADIO

FAV

MENU

TV/TXT CANCEL REVEAL NICAM/A2

INDEX HOLD SIZE

D.SET

D.MENU

D.LAND.SUB

SUBPAGE

EXIT

TV/RADIO To switch to TV or Radio state in DTV mode.

INPUT : Press to display the input source menu.

DISPLAY: Press to display the current mode’s information.

MENU: System setup menu.
EXIT: Exit the OSD menu.

CH / : Scan through channels.

VOL+ /- : Adjust the volume.

EPG: To show the Electronic Program Guide during no-menu

state only in DTV mode.

POWER: Turn the TV on/standby.
MUTE: Press to mute the sound, press again or press

VOL+ to unmute.

SUBTITLE: Turn on/off the subtitle display in DTV mode

PICTURE: Select the picture mode.
ASPECT: Change the screen display mode.

SOUND: Select the sound mode.

SLEEP: Standby timer.

CH.LIST: Display the channel list.

CURSOR KEYS OK

Allows you to navigate the on-screen menus and adjust the
system settings to your preference.

NUMBER BUTTONS
Press 0-9 to select a TV channel directly when you

are watching TV.

: Return to the previous channel viewed.

FAV: Display the favorite program list.

:

Load/eject DVD disc.

Remote Control

7

Remote Control

POWER MUTE

PICTURE ASPECT SOUND

SLEEPSUBTITLE

CH.LIST

123

456

789

0

VOL CH

INPUTDISPLAY

EPG

TV/RADIO

FAV

MENU

TV/TXT CANCEL REVEAL NICAM/A2

INDEX HOLD SIZE

D.SET

D.MENU

D.LAND.SUB

SUBPAGE

EXIT

D.SET: DVD system setup.

D.SUB: Turn on/off the subtitle display in DVD mode.
D.LAN: Select DVD disc language.

D.MENU: DVD play list/Disc menu.

:

:

:

:
:

:

Stop program.

Previous chapter.
Next chapter.
Play/Pause program.

Fast reverse.
Fast forward.

NICAM/A2: TV Nicam/A2 select.

TV/TXT: Turn off/on the Teletext display.
CANCEL: Cancel the Teletext display.
REVEAL: Reveal any hidden text.

HOLD:

Hold or carry on the current subpage.

SIZE: Press to see top half of page double size,

Press again to see the bottom
half of page double size. Press again for normal size.

SUBPAGE: Press to enter subpages, pressagain to cancel.

INDEX: Go to index.

Colour buttons: Short cuts-follow the coloured links in the text.

AUTO INSTALLATION

8

AUTO INSTALLATION

Setup 1:Set up the Country

Setup 2:Set up the Language

Setup 3:Set up the Auto Power Off