CarAlarms.com 159 User Manual

Excalibur

Vibrating

Pinball

OPERATING MANUAL

www.ExcaliburElectronics.com

Model No. 159

ongratulations on your purchase of Excalibur

C

Electronics’ Vibrating Pinball!
most fun from your new game, please read

To get the

this operating manual thoroughly, paying special
attention to safety and care instructions.

Installing Batteries

Your game requires 2 AAbat­teries (not included). To in­stall the batteries, carefully
turn the game over so that the
top side is face-down on a
soft surface. Use a small
Phillips screwdriver to
remove the screw. Lift off the
battery compartment lid.
Install the 2 AA batteries,
making sure to match the
polarity (+ and -) with the
diagram inside the battery

compartment. Place the bat­tery compartment lid’s tabs in
their slots and snap the com­partment door back on.
Replace the screw and gently
tighten it.

Layout of Vibrating Pinball

Your Vibrating Pinball buttons
are easy to use.

LEFT FLIPPER Press to activate
your left flipper when playing
pinball. Also press this button to
select Game 1 or Game 2.

RIGHT FLIPPER Press this to acti­vate your right flipper when play­ing pinball. Also, press and hold
it to eject a ball, or press to select
a level before starting a game.

PLUNGER Pull and release to put
a ball in play.

STAR T Press to start a game.
ON Press to turn your game on.
RESET Press to reset your game.
PAUSE Press to pause during a

game, or to resume a game.

SOUND Press to turn the sound on
or off.

Flip-up scoreboard

Score
LCD

PAUS

SOUND

LEFT
FLIPPER

32

Flashing
Lights

Pinball
LCD

PLUNGER

STAR

ON

RESET

RIGHT
FLIPPER

Playing Vibrating Pinball

Getting started

To begin playing, flip up the
automatic scoreboard so that you
can see the score LCD at the top
of the unit. Then press
on the game. Next press

FLIPPER

to select either Game 1
or Game 2. The game selection
will be displayed on the upper
right of the pinball LCD.

Choosing levels

Press RIGHT FLIPPER to choose
one of six levels, ranging in diffi­culty from Level 1, the easiest, to
Level 6, the most difficult. The
level selected will be displayed

ON to turn

LEFT

If no button is pushed for a few minutes, your

Vibrating Pinball game will

switch off to save your batteries.

on the score LCD. After you have
made your selection, press
to begin your game.

Putting the ball in play

You can launch a ball either by
pulling and then releasing the

PLUNGER, or by pressing and

holding RIGHT FLIPPER. Once
the ball is released, use your flip­pers to keep the ball in play.

Playing the game

You’ll be challenged by three
balls per game. To score points,
you need to knock the bricks and
hit the bubbles with each pinball.

4

START

Computers can sometimes “lock up” due to static

discharge or other electrical disturbances. If this

should happen, reset the game by pressing

You get extra points for knocking
the pinball inside the spinning
wheel.

Pausing during a game

If you’d like to pause during the
game, simply press PAUSE. Press
again to resume your game.

Sound on/off

Press the SOUND button if you’d
like to switch the pinball arcade

sounds off. Press again if you’d
like to turn the sound back on.

Your Excalibur Pinball will pro­vide you hours of fun. Please
review the safety, care and bat­tery instructions on the following
page. And please remember to
close the flip-up scoreboard dis­play when not in use to avoid
damaging it.

RESET.

SPECIAL CARE & HANDLING

• Avoid rough handling
such as bumping or dropping.

• Avoid moisture and
extreme temperatures. For
best results, use between the

temperatures of 39ºF and
100ºF (4º C and 38º C).

• Clean using only a slightly
damp cloth. Do not use clean­ers with chemical agents.

5

BATTERY INFORMATION

• CAUTION: Batteries should
be removed and replaced by
adults only.

• Turn unit off when installing
batteries.

• Your Pinball game uses 2 AA
batteries, not included.

• Do not mix alkaline, standard
(carbon-zinc) or rechargeable
(nickel-cadmium) batteries.

• Do not mix old and new bat­teries.

• Do not use rechargeable bat­teries.

• Remove exhausted batteries
from the unit.

Due to continuing improvements, actual
product may differ slightly from the
product described herein.

• Do not short circuit battery
terminals.

• Remove batteries and store
them in a cool, dry place when
not in use.

• To avoid explosion or leak­age, do not dispose of batteries in
a fire or attempt to recharge
alkaline or other non-recharge­able batteries.

• Install batteries so that the
polarity (+ and -) matches the
diagram in the battery compart­ment.

• Use only batteries of the same
type and equivalency.

LIMITED 90-DAY WARRANTY

EXCALIBUR ELECTRONICS,
INC., warrants to the original con­sumer that its products are free from
any electrical or mechanical defects
for a period of 90 DAYS from the date
of purchase. If any such defect is dis­covered within the warranty period,
EXCALIBUR ELECTRONICS,
INC., will repair or replace the unit
free of charge upon receipt of the unit,
shipped postage prepaid and insured
to the factory address shown at right.

The warranty covers normal con­sumer use and does not cover damage
that occurs in shipment or failure that
results from alterations, accident, mis­use, abuse, neglect, wear and tear,
inadequate maintenance, commercial
use, or unreasonable use of the unit.
Removal of the top panel voids all
warranties. This warranty does not
cover cost of repairs made or attempt­ed outside of the factory.

Any applicable implied warranties,

including warranties of merchantabil­ity and fitness, are hereby limited to
90 DAYS from the date of purchase.
Consequential or incidental damages
resulting from a breach of any appli­cable express or implied warranties
are hereby excluded. Some states do
not allow limitations on the duration
of implied warranties and do not allow
exclusion of incidental or consequen­tial damages, so the above limitations
and exclusions in these instances may
not apply.

The only authorized service center in
the United States is:

Excalibur Electronics, Inc.

13755 SW 119th Ave

Miami, Florida 33186 U.S.A.

Phone: [phone]

Fax: [phone]

Play games live at:

www.ExcaliburElectronics.com

Ship the unit carefully packed, prefer-

76

ably in the original carton, and send it
prepaid, and adequately insured.
Include a letter, detailing the com­plaint and including your daytime
telephone number, inside the shipping
carton.

If your warranty has expired and you
want an estimated fee for service,

write to the above address, specifying
the model and the problem.

PLEASE DO NOT SEND

YOUR UNIT WITHOUT

RECEIVING AN ESTIMATE FOR

SERVICING. WE CANNOT

STORE YOUR UNIT!

We make you think.