5
* Please disconnect the appliance from power
mains, before carrying out any cleaning or
maintenance operation.
If the appliance is not equipped with a nonseparable flexible cable and plug, or with
another device ensuring omnipolar
disconnection from the mains, with an
opening distance between the contacts of
at least 3 mm, then such disconnecting
devices must be provided in the fixed
installation.
If the appliance is equipped with a power
cord and a plug, it shall be placed in such a
way that the plug can be reached easily.
* The use of materials which can burst into
flames should be avoided in close
proximity of the appliance. When frying,
please pay particular attention to fire risk
due to oil and grease. Being highly
inflammable, fried oil is especially
dangerous. Do not use uncovered electric
grills.
In order to avoid possible fire risk, all
instructions for grease-filter cleaning
and for removing eventual grease
deposits should be strictly followed.
WARNINGS
* The appliance is not intended for use by
young children or infirm persons without
supervision. Young children should be
supervised to ensure they do not play
with the appliance.
* The minimum distance between the
cooking surface and the lower part of
the cooker hood shall be 400 mm. For
LUC600 and ZZ801 MODELS, the minimum
distance shall be 650 mm.
* The extracted air can’t be conveyed
through or into a duct used to let out
fumes from appliances fed by energy
other than electric power (eg. centralized
heating, radiators, water heaters, etc.).
* To evacuate the air outlet, please comply
with the pertaining rules given by
competent authorities.
* Provide the room with an adequate aeration
when a cooker hood and appliances fed by
energy other than electric power (gas, oil, or
coal stoves, etc.) are used simultaneously. The
cooker hood, when evacuating the extracted
air, could generate a negative pressure in the
room which can’t exceed the limit of 0.04
mbar, in order to avoid the suck of exhausts
deriving from the heat-source. Therefore the
room should be provided with air-intakes to
allow a constant flow of fresh air.
If the rating label in the cooker hood
shows the symbol , the appliance is
built in class II° and it does not need any
earth connection.
If the rating label in the cooker hood does
not show the symbol , the appliance is
built in class I° and it needs the earth
connection.
* When performing the electrical connections
on the appliance, please make sure that the
current-tap is provided with earth connection
and that voltage values correspond to those
indicated on the r
ating label placed inside
the appliance itself.
USES
The appliance has been designed to
work both in recirculating and external
extraction modes.
* In the recirculation mode (fig. 1), the air and
fumes conveyed by the appliance are
purif
ied by both a grease filter and an
activated charcoal filter, and then
recirculated back into the room through
the vent slots in the chimney. When the
appliance works in this mode, we
recommend the use of an air deflector
(Fig.1A) to be placed on the upper part of the
pipe, allowing the air to be re-circulated into
the room .
* In the External extraction mode (fig. 2),
fumes are directly conveyed outside the
building, through the top or rear air outlet.
The use of a charcoal filter and air
deflector is not necessary in this case.