Caple Wi6221 Instruction Manual

INSTRUCTIONS FOR USE

WINE CABINETS

WCI30B Slot-in

Wi3112 Slot-in
Wi6221 Slot-in
Wi6111 Slot-in

For Spare Parts, Technical Advice

or Product Service call the

CAPLE HELPLINE on 0870 850 8734

1 of 8

Thank you for buying your new CAPLE Wine Cabinet. To ensure that you get the best
results from your new purchase, we strongly suggest that you read this instruction
manual thoroughly before use. This manual contains installation advice, usage
instructions and other important facts about your CAPLE Wine Cabinet. If treated with
care, your CAPLE Wine Cabinet should give you many years of trouble-free use.

IMPORTANT WARNINGS AND ADVICE

• Unpack your wine cabinet carefully and remove all of the protective packing from inside
and outside.

• Packing (plastic bags, polystyrene, nails, metal, etc.) must not be left within the reach of
children as they are a potential source of danger.

• After unpacking, make sure that the appliance is in pe rfect order . If you have any doubt, do
not use it and contact your retailer.

• Check that all the fittings are in the correct position on the inside of the cabinet.

• Release the mains lead which is fitted with a 13 amp UK type plug.

• Move your wine Cabinet to its final location.

• DO NOT MOVE YOUR CABINET WHILE LOADED WITH WINE as this could distort the

cabinet.

• Ensure that the specified ventilation instructions are adhered to.

• Do not try to modify the appliance's technical characteristics as this could be dangerous

• This appliance should only be used for the specific purpose for which it was de si gned, i.e.

storage of wine. It is not designed for food storage.

• Do not clean or maintain the appliance without disconnecting it first.

• To prevent damaging the door gasket, make sure that the door is fully

open when pulling shelves out.

• Ensure that you fully understand these instructions before operating this appliance.

• Caple are NOT responsible for: -

1. Damage caused by incorrect, mistaken or irrational use.

2. For any errors in this manual, or for any damage linked to or following the
provision, performance or use of any wine Cabinet.

The information in this document is subject to modification without prior notice.

•

DISPOSAL OF OLD APPLIANCE

Discarded appliances are potentially dangerous to CHILDREN.

Before you throw away your old Wine Cabinet:

• Remove the door. Leave the shelves in place so that children cannot easily climb

inside.

• Never allow children to operate, play with, or climb inside the appliance.

2 of 8

INSTALLATI ON INSTRUCTIONS

BEFORE TURNING THE WINE CABINET ON ENSURE IT IS PERFECTLY LEVEL. This will

minimise any vibrations.
Your cabinet is equipped with 4 adjustable feet. However, we recommend that you tighten the
back feet to the maximum and then use the front feet to level the cabinet.

IMPORT ANT: WAIT 2 HOURS BEFORE TURNING THE WINE CABINET ON FOR THE FIRST
TIME.

Safety Instructions

• A fan evacuates heat via the bottom vents.

• It must be installed well away from any heat source.

• It must not be placed in direct sun light.

• It must not be in a damp location (laundry, pantry, bathroom, etc)

• It must be perfectly level.

• It must have a correctly installed and reliable electricity supply correctly earthed.

• Use of a multi-socket or extension lead is not recommended.

• This wine Cabinet must be earthed to provide protection in the event of an electrical

short circuit.

• It is fitted with a power cord having an earth wire terminating in a 13amp plug.

• Consult a qualified electrician or service engineer if the earthing instructions are not

completely understood.
WARNING: INCORRECT EARTHING CAN RESULT IN THE RISK OF ELECTRIC SHOCK.
Door reversal
WE RECOMMEND THAT SOMEONE ASSISTS YOU DURING THIS PROCESS. TOOLS
REQUIRED: - PHILIPS SCREWDRIVER. (A BOTTOM LEFT HAND HINGE IS SUPPLIED
WITH WINE CABINET.

1. Lay the unit on its back.

2. Remove the two (2) screw from the lower hinge

3. Remove the door from the cabinet and carefully set aside.

4. Remove the six (6) screw from top hinge module and Lower hinge module and remove
the hinge module.

Keep in a safe place in the event you ever need to revert back to a right hand door swing.)

(

5. Install the top hinge module and lower hinge module from attached sp are part with six (6)
screws.

6. Install the lower hinge to the left lower hinge module.

7. Carefully install the door on the cabinet. (Insert upper door into top hinge pin.)

8. Check alignment of door and door seal before tightening screws.

9. Tighten the two (2) screw from the lower hinge

10. Tighten all hinge screws.

11. Place unit in the upright position.

3 of 8