Caple Wi6123 Instruction Manual
1
INSTRUCTIONS FOR USE
WINE CABINETS
Wi6112 &WCi46B& Wi6123
Slot-in
WF331 Freestanding
For Spare Parts, Technical Advice
or Product Service call the
CAPLE HELPLINE on 0870 850 8734
2
Thank you for buying your new CAPLE Wine Cabinet. To ensure that you get the best
results from your new purchase, we strongly suggest that you read this instruction
manual thoroughly before use. This manual contains installation advice, usage
instructions and other important facts about your CAPLE Wine Cabinet. If treated with
care, your CAPLE Wine Cabinet should give you many years of trouble-free use.
IMPORTANT WARNINGS AND ADVICE
• Unpack your wine Cabinet carefully and remove all of the protective packing from inside
and outside.
• Packing (plastic bags, polystyrene, nails, metal, etc.) must not be left within the reach of
children as they are a potential source of danger.
• After unpacking, make sure that the appliance is in perfect order. If you have any doubt,
do not use it and contact your retailer.
• Check that all the fittings are in the correct position on the inside of the cabinet.
• Release the mains lead which is fitted with a 13 amp UK type plug.
• Move your wine Cabinet to its final location.
• DO NOT MOVE YOUR CABINET WHILE LOADED WITH WINE as this could distort the
cabinet.
• Ensure that the specified ventilation instructions are adhered to.
• Do not try to modify the appliance's technical characteristics as this could be dangerous
• This appliance should only be used for the specific purpose for which it was designed, i.e.
storage of wine. It is not designed for food storage.
• Do not clean or maintain the appliance without disconnecting it first.
• To prevent damaging the door gasket, make sure that the door is fully
open when pulling shelves out.
• Ensure that you fully understand these instructions before operating this appliance.
• Caple are NOT responsible for: -
1. Damage caused by incorrect, mistaken or irrational use.
2. For any errors in this manual, or for any damage linked to or following the
provision, performance or use of any wine Cabinet.
• The information in this document is subject to modification without prior notice.
DISPOSAL OF OLD APPLIANCE
Discarded appliances are potentially dangerous to CHILDREN.
Before you throw away your old Wine Cabinet:
• Remove the door. Leave the shelves in place so that children cannot easily climb
inside.
• Never allow children to operate, play with, or climb inside the appliance.
3
INSTALLATION INSTRUCTIONS
BEFORE TURNING THE WINE CABINET ON ENSURE IT IS PERFECTLY LEVEL. This will
minimise any vibrations.
Your cabinet is equipped with 4 adjustable feet. However, we recommend that you tighten the
back feet to the maximum and then use the front feet to level the cabinet.
IMPORTAN T: WAIT 2 HOURS BEFORE TURNING THE WINE CABINET ON FOR THE
FIRST TIME.
SAFETY INSTRUCTIONS
Freestanding model WF331
• The place you have selected for your cabinet should be well ventilated.
• This is a FREESTANDING product and the sides and top of the cabinet must have a
clear 10cm air gap to allow for cooling.
• A minimum 10cm space must be left between the wall and the back of the cabinet.
Slot-in model WCi46B / Wi6123 /Wi6112
• A fan evacuates heat via the bottom vents.
• It must be installed well away from any heat source.
• It must not be placed in direct sun light.
• It must not be in a damp location (laundry, pantry, bathroom, etc)
• It must be perfectly level.
• It must have a correctly installed and reliable electricity supply correctly earthed.
• Use of a multi-socket or extension lead is not recommended.
• This wine Cabinet must be earthed to provide protection in the event of an electrical
short circuit.
• It is fitted with a power cord having an earth wire terminating in a 13amp plug.
• Consult a qualified electrician or service engineer if the earthing instructions are not
completely understood.
WARNING: INCORRECT EARTHING CAN RESULT IN THE RISK OF ELECTRIC SHOCK.
4
DOOR REVERSAL (For Wi6123 / Wi6112)
WE RECOMMEND TH AT SOMEONE ASSISTS YOU DURING THIS PROCESS. TOOLS
REQUIRED: PHILIPS SCREWDRIVER. (A BOTTOM LEFT HAND HINGE IS SUPPLIED
WITH EACH CABINE T.)
Bottom hinge (Right) Screws Door axis
Door Top hinge(Right) Lock screws
Top hinge(Left) Bottom(Left)
1. Remove 2 screws ②, then pull
door④ As per arrowhead direction, you
will remove the door. Please remove
bottom hinge②as well for the coming
assembly. (Fig.A & Fig.B)
2. To remove 3 screws⑥ of right upper
Hinge, then to remove right upper⑤ &
Right lower hinges①; (See fig.C)
3. To use the screws which you removed
From right side hinges to fix left upper
& lower hinges (See Fig.D & Fig.E)
4. To rotate door at 180 degrees,
then assemble the door as per the
reverse way of remove.
Loading...