Caple WCF32, WCI45, WCI46B Instructions For Use Manual

1 of 8

INSTRUCTIONS FOR USE

WINE CELLARS
WCI45 & 46B Built-in
WCF32 Freestanding

For Spare Parts, Technical Advice

or Product Service call the

CAPLE HELPLINE on 0870 850 8734

2 of 8

Thank you for buying your new CAPLE Wine Cellar. T o ensure that you get the best
results from your new purchase, we strongly suggest that you read this instruction

manual thoroughly before use. This manual contains installation advice, usage

instructions and other important facts about your CAPLE Wine Cellar . If treated with

care, your CAPLE Wine Cellar should give you many years of trouble-free use.

IMPORTANT WARNINGS AND ADVICE

• Unpack your cabinet carefully and remove all of the protective packing from inside and
outside the wine cellar.

• Packing (plastic bags, polystyrene, nails, metal, etc.) must not be left within the reach of
children because they are a potential source of danger.

• After unpacking, make sure that the appliance is in perfect orde r . If you have any doubt, do
not use it and contact the retailer or call a qualified engineer.

• Check that all the fittings are in the correct position on the inside of the cabinet.

• Release the mains lead which is fitted with a 13 amp UK type plug.

• Move your wine cellar to its final location.

• DO NOT MOVE YOUR CABINET WHILE LOADED WITH WINE as this could distort the

cabinet.

• Ensure that the specified ventilation instructions are adhered to.

• Do not try to modify the appliance's technical characteristics because this could be

dangerous

• This appliance should only be used for the specific purpose for which it was designed, i.e
storage of wine. It is not designed for food storage.

• Do not clean or maintain the appliance without previously di sconnecting it.

• Ensure that you fully understand these instructions before operating this appliance.

• The manufacturer is not responsible for damage caused by incorrect, mistaken or irrational

use.

• Caple cannot be held responsible for any errors in this manual, or for any damage linked to
or following the provision, performance or use of wine cellar.

• The information in this document is subject to modification without prior notice.

DISPOSAL OF OLD APPLIANCE

Discarded appliances are potentially dangerous to CHILDREN.

Before you throw away your old Wine Cellar:

• Take off the door . Leave the shelves in place so that children may not easily climb

inside.

• Never allow children to operate, play with, or crawl inside the appliance.

3 of 8

INSTALLATION INSTRUCTIONS

BEFORE TURNING ON THE WINE CELLAR ENSURE IT IS PERFECTLY LEVEL

Your cabinet is equipped with 4 adjustable feet. However, we do recommend that you tighten
the back feet to the maximum and use the front feet to create a level.

Stainless Steel Plinth for WCi46B (Supplied separately)

When the Wine Cellar is installed in the final position the stainless steel plinth sh ould be fitted:
Remove the protective tape from the adhesive strips on the rear of the plinth.

• Place firmly in position onto the bottom of the Wine Cellar cabinet.

THE FLOW OF AIR THROUGH THE GRILL MUST NOT BE OBSTRUCTED AT ANY
TIME. FAILURE TO ADHE RE T O THIS WILL INVALIDATE THE GUARANTEE.

DOOR REVERSAL

WE RECOMMEND SOMEONE ASSIST YOU DURING THIS PROCESS. T OOLS REQUIRED:
PHILIPS SCREWDRIVER. ALSO SUPPLIED WITH EACH CABINET IS A LEFT HAND
BOTTOM HINGE.

• Lay the unit on its back.

• Remove the three (3) screws from the bottom hinge and remove the bottom hinge.

NOTE: Keep this hinge in a safe place in the event you ever need to revert back to a right hand
door swing.

• Remove the door from the cabinet and carefully set aside.

• Remove the two (2) plastic screw covers located on top of the hinge cover.

• Remove the screws holding the hinge cover to the top hinge.

• Remove the three (3) plastic screw covers from the top hinge.

• Remove the top hinge.

• Remove the three (3) plastic screw covers from the top left side of the wine cellar.

• Install the top hinge on the left side of the unit and secure with three (3) screws.

• Install the hinge cover back on the top hinge.

• Install the two (2) plastic screw covers to the top right hand side of the cabinet.

• Carefully install the door on the cabinet. (Insert upper door into top hinge pin.)

• Using the left hand bottom hinge (To order), insert the hinge pin into the bottom of the

door. (Align the hinge holes with the holes in the cabinet, and secure to cabinet with
three (3) screws.

• Check alignment of door and door seal before tightening screws.

• Tighten all hinge screws.

• Place unit in the upright position.

IMPORTANT: WAIT 2 HOURS BEFORE TURNING ON THE WINE CELLAR.