Caple WC6115 Instruction Manual

1
Instruction manual for in-column wine cabinet
Model code: WC6115
Contact Caple on 0844 800 3830 or for spare parts www.4caple.co.uk
2
WARNING
IMPORTANT SAFETY INSTRUCTIONS
aWARNINGa
To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these basic precautions:
Read all instructions before using the Wine cabinet.
DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are still dangerous . . . even if they will “just sit in the garage a few days”.
Before you throw away your old Wine cabinet: Take off the door. Leave the
shelves in place so that children may not easily climb inside.
Never allow children to operate, play with, or crawl inside the appliance.
Never clean appliance parts with flammable fluids. The fumes can create a fire
hazard or explosion.
Do not store or use gasoline or any other flammable vapours and liquids in the
vicinity of this or any other appliance. The fumes can create a fire hazard or explosion.
The refrigerant of these appliances are R600a ,
Flammable and explosive
articles should not be put in or near the cabinet, to avoid the risk of fire or explosion
-Keep these instructions-
z To prevent damaging the door gasket, make sure to have the door all the way
opened when pulling shelves out of the rail compartment.
z The appliance must be positioned so that the plug is accessible. Release the
power cord. Move your cabinet to its final location. Do not move your Cabinet while loaded with wine. You might distort the body. The wine cellar should be installed in a suitable place in order to avoid touching the compressor with the hand.
z If the supply cord is damaged, it must be replaced by a Caple service agent or a
similarly qualified person in order to avoid a hazard.
PLEASE DON’T TRY TO EXTEND THE ELECTRICAL CABLE IN ANY WAY.
3
INSTALLATION INSTRUCTIONS
¾ Before Using Your Wine cabinet
Remove the exterior and interior packing.
Before connecting the Wine cabinet to the power source, let it stand upright for
approximately 12 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
When disposing your appliance, please choose an authorized disposal site.
¾ Installation of Your Wine cabinet
Place your Wine cabinet on a floor that is strong enough to support it when it is fully
loaded. To level your Wine cabinet, adjust the front levelling leg at the bottom of the Wine cabinet.
Locate the Wine cabinet away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.
Avoid locating the unit in moist areas.
Plug the Wine cabinet into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorised Caple service centre.
¾ Attention
Store wine in sealed bottles;
Do not overload the cabinet;
Do not open the door unless necessary;
Do not cover shelves with aluminium foil or any other shelf material which may prevent air
circulation;
Should the Wine cabinet be stored without use for long periods it is suggested, after a
careful cleaning, to leave the door ajar to allow air to circulate inside the cabinet in order to avoid possible formations of condensation, mould or odours.
4
OPERATING YOUR WINE CABINET
AND SETTING THE TEMPERATURE CONTROL
Please use the cabinet within an ambient temperature of 5-32 °C. If the ambient temperature is higher or lower than this, it will cause temperature fluctuations in the cabinet.
¾ Controls
This is the LCD touch control panel.
“Power”
When the indicator light is on, the power for the machine is on.
“ ”
This shows the temperature of the internal cabinet.
“ ” Button
1) Used to raise the temperature by 1°C;
2) Also used to adjust the clock (increase 1 min or 1 hour)
“ ” Button
1) Used to reduce the temperature by 1°C;
2) Used to adjust the clock (decrease 1 min or 1 hour)
Button
1) To turn the inner light on/off.
Press this button, the light is on, and the light is not controlled by door. Press this button again, the light is off, and the light is controlled by door.
2) Also used to set up time mode/Light Control mode change.
Button
To turn this appliance on/off.
Press this button, the power is on. Press this button with 3 seconds again, the power is off.
Display Clock .
Alarm Indicator light.
Power
Loading...
+ 8 hidden pages