Caple WC6112 Instruction Manual

1
Instruction manual for
Instruction manual for Instruction manual for
Instruction manual for iiiin
n n
n ccccol
olol
oluuuumn
mnmn
mn wwwwine cabinet
ine cabinetine cabinet
ine cabinet
Model code: WC6112
Contact Caple on 0844 800 3830 or for spare parts www.4caple.co.uk
2
Thank you for buying your new Caple Wine Cabinet. To ensure that you get the best results from your new purchase, we strongly suggest that you read this instruction manual thoroughly before use. This manual contains installation advice, usage instructions and other important facts about your CAPLE Wine Cabinet. If treated with care your CAPLE Wine Cabinet should give you many years of trouble free use.
IMPORTANT WARNINGS AND ADVICE
Unpack your wine cabinet carefully and remove all of the protective packing from inside and
outside.
Packing (plastic bags, polystyrene, nails, metal, etc.) must not be left within the reach of
children as they are a potential source of danger.
After unpacking, make sure that the appliance is in perfect order. If you have any doubt, do not
use it and contact your retailer.
Check that all the fittings are in the correct position on the inside of the cabinet.
Release the mains lead which is fitted with a 13 amp UK type plug.
Move your wine cabinet to its final location.
DO NOT MOVE YOUR CABINET WHILE LOADED WITH WINE as this could distort the cabinet.
Ensure that the specified ventilation instructions are adhered to.
Do not try to modify the appliance's technical characteristics as this could be dangerous.
This appliance is intended to be used exclusively for the storage of wine. It is not designed for
food storage.
Do not clean or maintain the appliance without disconnecting it first.
To prevent damaging the door gasket, make sure that the door is fully open when pulling
shelves out.
Ensure that you fully understand these instructions before operating this appliance.
Caple are NOT responsible for: -
1. Damage caused by incorrect, mistaken or irrational use.
2. Any errors in this manual, or for any damage linked to or following the provision, performance or use of any wine cabinet.
The information in this document is subject to modification without prior notice.
DISPOSAL OF OLD APPLIANCE
Discarded appliances are potentially dangerous to CHILDREN.
Before you throw away your old Wine Cabinet:
Remove the door. Leave the shelves in place so that children cannot easily climb inside.
Never allow children to operate, play with, or climb inside the appliance.
3
INSTALLATION INSTRUCTIONS
BEFORE TURNING THE WINE CABINET ON ENSURE IT IS PERFECTLY LEVEL. This will minimise any vibrations. Your cabinet is equipped with 4 adjustable feet. However, we recommend that you tighten the back feet to the maximum and then use the front feet to level the cabinet. IMPORTANT: WAIT 12 HOURS BEFORE TURNING THE WINE CABINET ON FOR THE FIRST TIME.
Safety Instructions
A fan evacuates heat via the bottom vents.
It must be installed well away from any heat source.
It must not be placed in direct sun light.
It must not be in a damp location (laundry, pantry, bathroom, etc)
It must be perfectly level.
It must have a correctly installed and reliable electricity supply correctly earthed.
Use of a multi-socket or extension lead is not recommended.
This wine cabinet must be earthed to provide protection in the event of an electrical short
circuit.
It is fitted with a power cord having an earth wire terminating in a 13amp plug.
Consult a qualified electrician or service engineer if the earthing instructions are not
completely understood.
WARNING: INCORRECT EARTHING CAN RESULT IN THE RISK OF ELECTRIC SHOCK.
4
OPERATING YOUR WINE CABINET
AND SETTING THE TEMPERATURE CONTROL
The wine cabinet should be placed where the ambient temperature is between 5-32 deg centigrade. If the ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate and maybe can not reach the setting temperarture.
The controls of your Wine cooler
LCD touch panel.
“Power”
When the indicator light is on, the power for the machine is on.
“ ”
To shows the temperature of the internal cabinet.
“ ” Button
1>Used to raise the temperature 1 °C; 2>Used to adjust the clock( increase 1 min or 1 hour)
“ ” Button
1>Used to reduce the temperature 1 °C; 2>Used to adjust the clock (decrease 1 min or 1 hour)
Button
1>To control the inner light turn on/off.
(Press this button, the light is on, and the light is not controlled by door. Press this button again, the light is off, and the light is controlled by door.) 2>Set up time mode/ light control mode change.
Button
To control the power, turn the appliance on/off.
(Press this button, the power is on. Press this button with 3 seconds again, the power is off.)
Display Clock .
Alarm Indicator light.
Power
Loading...
+ 8 hidden pages