Caple RiL871 Instruction Manual
RiL871
Domestic RefrigeratorDomestic Refrigerator
Domestic Refrigerator
Domestic RefrigeratorDomestic Refrigerator
Operation InstructionsOperation Instructions
Operation Instructions
Operation InstructionsOperation Instructions
ContentsContents
Contents
ContentsContents
Cautions------------------------------------------------------------------1~2
Refrigerator diagram-------------------------------------------------3
Preparation--------------------------------------------------------------4~6
Operation----------------------------------------------------------------7
Instructions-------------------------------------------------------------8~10
Defrosting, cleaning and de-commissioning------------------11~12
Trouble shooting -----------------------------------------------------13~14
Cautions
Disposal of the old appliance
Before disposing an old appliance, please make sure it’s inoperative and safe. Unplug
the appliance and remove or destroy all of the springs, latches, or bolt-locks in order to
avoid the risk of child entrapment.
It must be noted that the refrigeration system contains insulating gases and refrigerants,
which require specialized waste disposal. The valuable materials contained in a refrig-
erator can be recycled. Contact your local waste disposal center for proper disposal of
an old appliance and contact your local authority or your dealer if you have any ques-
tion. Please ensure that the pipe work of your refrigerator dose not get damaged prior to
being picked up by the relevant waste disposal center, and contribute to environmental
awareness by insisting on an appropriate, any-pollution method of disposal.
Disposal of the packaging of your new appliance
All the packaging materials employed in the package of your new appliance may be
disposed without any danger to the environment.
The cardboard box may be broken or cut into smaller pieces and given to a waste paper
disposal service. The wrapping foil is made of polyethylene and the polyethylene pads
and stuffing contain no fluorochloric hydrocarbon.
All these valuable materials may be taken to a waste collecting center and used again
after adequate recycling.
Consult your local authorities for the name and address of the waste materials collect-
ing centers and waste paper disposal services nearest to your house.
Safety Instructions and Warnings
Before starting the appliance, read the information given in the User’s Guide carefully.
The User’s Guide contains very important observations relating to the assembly,
operation and maintenance of the appliance.
Keep the User’s Guide in a safe place and remember to hand it over to the subsequent
owner, if you ever sell the appliance.
The manufacturer does not accept responsibility for any damages that may arise due to
non-observation of the following instruction.
*Damaged appliances are not to be put into operation. In case of doubt ,consult your
supplier.
1
Cautions
2
Refrigerator Diagram
1
2
3
4
5
1.Shelves
2.Vegetable and fruit tray
3.Temperature Controller
4.Egg tray
5.Bottle racks
This diagram may vary slightly with the layout of the refrigerator you have
just purchased due to technical improvements.
3
Preparation
Unpacking
Remove all packing materials.
Check attachments and materials
Checking should be conducted with reference to the Packing List. Contact the local
distributor if discrepancies are found.
Ensure proper location of the refrigerator.
Clean the refrigerator before use.
(See the following section “Cleaning”)
Idle time
After the refrigerator has been sited and cleaned, let it stand for more than 30 minutes
before connecting the power source
Left/Right Door Opening
The door of the refrigerator can be opened both from the left or right as required. The
following are the steps required to position the door to open to the right.
1. Remove the lower bracket (1) on the right, the door and the screw hole cover (4).
2. Remove the lower bracket pivot (3) and the spring washer(2), and then place and fix
them in the hole on the left of the lower bracket.
3. Remove the cover (5) on the upper brackets on both left and right sides; remove the
bracket pivot on the right side and the spring washer and then fix them in the bracket
hole.
4. Fix the door between the upper and lower brackets on the left and fasten the lower
bracket by tightening the screws.
5. Fix the screw hole cover in the lower bracket hole on the right, and then fix the upper
bracket covers to the upper brackets on the left and right.
6. After installation open and close the door to ensure the door operates smoothly.
（（
（Figure A
（（
））
）
））
4
Loading...