1. Compression-type appliances which use flammable refrigerants shall be marked
with the
symbol “Caution: risk of fire”.
Caution:risk of fire
The height of the triangle in the symbol “Caution: risk of fire” shall be at least 15 mm.
2.
– WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in
structure, clear of obstruction.
– WARNING: Do not use mechanical devices or other means to accelerate the defrosting
process, other than those recommended by the manufacturer.
– WARNING: Do not damage the refrigerant circuit.
– WARNING: Do not use electrical appliances inside the food storage compartments of
liance, unless they are of the type recommended by the manufacturer.
app
the
Do not store explosive substances such as aerosol cans with a flammable propellant in
this appliance.
3.
If the supply cord is damaged, it must be replaced by a special cord or assembly available
from the manufacturer or its service agent.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given
supervis
ion or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance.
Cautions
Disposal of the old appliance
Before disposing an old appliance, please make sure it’s inoperative and safe. Unplug
the appliance and remove or destroy all of the springs, latches, or bolt-locks in order to
avoid the risk of child entrapment.
It must be noted that the refrigeration system contains insulating gases and refrigerants,
which require specialised waste disposal. The valuable materials contained in a refrigerator
can be recycled. Contact your local waste disposal center for proper disposal of
an old appliance and contact your local authority or your dealer if you have any question.
Please ensure that the pipe work of your refrigerator dose not get damaged prior to
being pick
ed up by the relevant waste disposal center
Disposal of the packaging of your new appliance
All the packaging materials employed in the package of your new appliance may be
disposed without any danger to the environment.
The cardboard box may be broken or cut into smaller pieces and given to a waste paper
disposal service. The wrapping foil is made of polyethylene and the polyethylene pads
and stuffing contain no fluorochloric hydrocarbon.
All these valuable materials may be taken to a waste collection center and used again
adequate recycling.
after
Consult your local authorities for the name and address of the waste materi
centers and waste paper disposal services nearest to your house.
als collection
Safety Instructions and Warnings
Before starting the appliance, read the information given in the User’s Guide carefully.
The User’s Guide contains very important observations relating to the assembly,
operation and maintenance of the appliance.
Keep the User’s Guide in a safe place and remember to hand it over to the subsequent
owner, if you ever sell the appliance.
manufacturer does not accept responsibility for any damages that may arise due to
The
non-observation of the following instruction.
*Damaged appliances are not to be put into operation. In case of doubt ,consult your
supplier.
1
Cautions
to be carried out in strict compliance
*The refrigerating circuit is leak-proof
2
Refrigerator Diagram-- Preparation
1.Shelves
2.Vegetable and fruit tray
3.Temperature Controller
4.Egg tray
5.Bottle racks
This diagram may vary slightly with the layout of the refrigerator you have
just purchased due to technical improvements.
Preparation
Unpacking
Remove all packing materials.
Check attachments and materials
Checking should be conducted with reference to the Packing List. Contact the local
distributor if discrepancies are found.
Ensure proper location of the refrigerator.
*Make sure the refrigerator is kept upright during handling.If an inclination is required,
it should not exceed 45 degrees. Otherwise the appliance may get specialised
n compromised refrigeration performance.
i
*To avoid product damage or personal injury, the refrigerator should be unpacked
by two persons after it is located in a previously selected position.
*Before installation,make sure the refrigerator has no visible exterior damage.
*When handling the refrigerator, do not lift it by holding the worktop, to prevent
any damage to the refrigerator.
*Do not start up a refrigerator that is damaged.
Clean the refrigerator before use.
(See the following section “Cleaning”)
Idle time
After the refrigerator has been sited and cleaned, let it stand for more than 12 hours
before connecting the power source
3
Operation
Starting the refrigerator
After connecting to the power supply, turn the temperature
controller clockwise from position 0 to any position
between 1 and 7 to start the refrigerator. The refrigerator
compressor will stop when the temperature controller
is at position 0.
T
Adjusting the temperature:
The temperature inside the refrigerator is adjusted by turning the temperature
controller. Positions 1 to 7 represent different temperatures from the lowest to the
highest.
Position Conditions
1-2 Summer or ambient temperature between25-35℃
3-4 Spring, autumn or ambient temperature between15-25℃
4-5 Winter, or ambient temperature between5-15℃
6-7 Quick freeze
Caution: Some time will be required for the refrigerator to reach the set level when
temperature adjustments are made. The length of this period is determined by
difference in the existing and set temperatures, the ambient temperature, the frequency
with which the door is opened and closed and the amount of food in storage.
Loading the refrigerator with food
When the refrigerator is switched on, do not load food until 1~2 hours have passed.
Usually, food for cold storage or deep freezing can be loaded when the temperature
inside the compartment reaches the set point.
4
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.