Caple Oven Electronic Programmer User Manual

Page 1 of 3

ELECTRONIC PROGRAMMER.DOC

Electronic Programmer (6 Buttons)

A. Autotimer

The electronic programmer is a device which groups together the following functions: -

• 24 hour clock with illuminated display

• Timer (up to 23 hours and 59 minutes)

• Program for automatic oven cooking

• Program for semi-automatic oven cooking.

Description of the buttons:

Timer
Cooking time
End of cooking time
Manual position and cancellation of programmed cooking.
Advancement of the numbers of all programs.

Turning back of the numbers of all programs and changing the frequency of the audible
signal.

Description of the lighted symbols:

AUTO

- flashing -

Programmer in automatic position but not programmed.

AUTO

- always lighted -

Programmer in automatic position with program inserted.

Automatic cooking taking place.

Timer in operation.

And

AUTO - flashing -

Program error.

(The time of day lies between the calculated cooking start and end time).

NOTE: Select a function using the respective button and, in 5 seconds, set the

required time with the / buttons ("one-hand" operation).

A power-cut makes the clock go to zero and cancels the set programs.

Electronic Clock

The programmer is equipped with an electronic clock with lighted numbers which indicates
hours and minutes.

Upon immediate connection of the oven or after a power-cut, three zeros will flash on the
programmer panel.

To set the hour it is necessary to push the button and then the or button until
you have set the exact hour.

In another way push simultaneously the two buttons and at the same time push

the or button.

NOTE: The hour setting after programming deletes any program.

Page 2 of 3

ELECTRONIC PROGRAMMER.DOC

NORMAL COOKING WITHOUT THE USE OF THE PROGRAMMER

To manually use the oven, that is, without the aid of the programmer, it is necessary to

cancel the flashing AUTO by pushing the button (AUTO will be switched off and the

symbol will go on).

Attention: If the AUTO is steady lighted (which means a cooking program has already

been inserted), by pushing the button a you will cancel the program and revert to
manual operation.

If the oven is switched on, remember you must switch off manually.

ELECTRONIC TIMER

The timer program consists only of a buzzer which may be set for a maximum period of 23
hours and 59 minutes.

If the AUTO is flashing push the a button.

To set the time, push the button and the or until you obtain the desired time in
the panel (fig. 8). Having finished the setting, the clock hour will appear on the panel and

the symbol will be lighted.

The countdown will start immediately and may be seen at any moment on the panel by

simply pressing the button . At the end of the time, the symbol will be switched off
and an intermittent buzzer will sound; this can be stopped by pressing one of any of the
buttons.

SETTING THE FREQUENCY OF THE AUDIBLE SIGNAL

The selection from 3 possibilities of sound can be made by pressing the button. The last
setting remains on.

SETTING THE AUTOMATIC OVEN COOKING

To cook food automatically in the oven, it is necessary to:

1. Set the length of the cooking time.

2. Set the end of the cooking time.

3. Set the temperature and the oven cooking program.

These operations are done in the following way:

• Set the length of the cooking time by pushing the button and the button to

advance, or to go back if you have passed the desired time. The AUTO and the

symbol will be on.

• Set the end of the cooking time by pressing the button (the cooking time already

added to the clock time will appear), and the button; if you pass the desired time

you may get back by pushing the button.

After this setting, the symbol will go off. If after this setting, the AUTO
flashes on the panel and a buzzer sounds, it means there was an error in the
programming, that is that the cooking cycle has been superimposed on the clock.
In this case, modify the end of cooking time or the cooking time itself by
following again the above mentioned instructions.