Caple AXL50 Installation And Care Manual

INSTALLATION AND CARE GUIDE

Model code: AXL50

Customer care helpline: 0117 938 1900 ww w.caple.co.uk

INSET INSTALLATION GUIDE

For undermount installation please refer to the template provided with the sink.

Thank you for purchasing your Caple sink.
This sink have been manufactured with the finest quality 18/10 stainless steel and inspected to
exacting standards and is guaranteed to give years of trouble free operation providing our care and
installation guidelines have been followed.

1

Place the sink upside down in the position where it is to be installed,
and trace the outline of the sink on the worktop with a pencil.

4

2

8mm

420mm

520mm

Draw another line 10mm inside the first line, cut a hole in the worktop
following this second inner line. Alternatively for inset installation cut
a hole 520mm x 420mm as above to accomodate the sink.

5

Sink

30-40mm

(1)

Sink

25mm

(2)

3

Adhere the seal tape around the under side of the edge of the sink,
being careful to lay it smoothly (without ridges).

6

Place the fixing clips horizontally and pull them up to look into their
vertical position. Then position the sink into the worktop.

NOTE: Please see back page for care and maintenance instructions

The fixing clips are designed for use with worktops 30-40mm thick
(1). If your worktop is thinner, insert wooden wedges between the
counter top and the fixing clips to secure them (2). After placing two
at each corner of the sink, place the rest evenly spaced around the
perimiter of the sink.

Tighten the screws of the fixing clips (with a screwdriver), to secure
the sink in place.

CAUTION: Sink edges may be sharp, handle with care