Caple AUF900 User Manual

Instruction manual for Aufero island hood

Model code: AUF900

Contact Caple on 0844 800 3830 or for spare parts www.4caple.co.uk

Warning

Your cooker hood is for domestic use only, not suitable commercial use.
Keep children from using the cooker hood.
Any installation work must be carried out by a qualified electrician or
competent person.
The cooker hood and its filter mesh should be cleaned regularly in order to
keep in good working order.
Before cleaning, always ensure that you have switched your cooker hood off.
Clean the cooker hood according to the instruction manual and keep the
cooker hood from the danger of burning.
Do not use fire for drying your cooker hood.
If there is any fault with your cooker hood, please call the service department
appointed by Caple.
Please keep the room ventilated when your cooker hood and gas hob are
working.
Do not exhaust the cooker hood through the same heated flue which is used
for the gas hob or other kitchen appliances.

Thank you for purchasing this Caple cooker hood. Please read the instruction
manual carefully before you use the hood, and keep it in a safe place.

· The installation work must be carried out by a qualified electrician or competent
person. Before you use the cooker hood, make sure that the voltage (V) and the
frequency (Hz) indicated on the cooker hood are exactly the same as the voltage
(V) and the frequency (Hz) in your home.

· The manufacturer and the agent will not bear any responsibility for the damage
caused by inappropriate installation and usage.

Function and Feature

1. The cooker hood is made of high quality materials perfect your kitchen.

2. It is equipped with a high power low noise electric motor and centrifugal leaf,
it produces strong suction, low noise. It includes a non stick grease filter
which is easy to clean.

3. The grease filter is easy to remove and clean, only wipe the motor and other
interior parts lightly.

1

Installation

1. The ceiling must bear at least 120kgs weight, and the thickness of the ceiling

must be  30MM, see pic 1, drill 1*170mm round hole in the ceiling.

2. According to the hanging board, drill 12 holes in the ceiling, see pic 1, 12pcs

of ST6*40mm big flat screws will be used to fix the hanging board on the ceiling,
and then 8pcs of M4*10 screws and M4 nut with gasket will be used to connect
the angle iron into the hanging board, see pic 1, calculated the length of the
angle iron, and 16pcs M4*10 big flat screws and M4 nut with gasket will be used
to connect the angle iron and another angle iron ( the overlap length of angle
iron cannot be less than 100MM.)

3. Let the one side of the extensible pipe go outside through the hole of 170MM,

see pic 2.

4. 4pcs ST4*8 big flat screws will be used to connect the internal chimney into

the hanging board, then put one the external chimney, one hook will be used to
put up the external chimney in order to the next installation, see pic 3.

5. 4pcs ST4*8 big flat screws will be used to install the outlet, see pic 4 (if the air

suction of the motor is 1000m3/h, pls skip this step)

6. Hold up the hood, 16pcs M4*10 big flat screws will be used to connect the

hood body into angle iron, see pic 5.

7. Put the extensible pipe on the outlet; after ensuring all the fixings are ok, put

down the hook, take from the external chimney, all the installation is finished, see
pic 7.

2