capello Ci320, CR60 User Manual

User Guide
Bluetooth Speaker with Clock Ci320
IMPORTANT SAFETY NOTIFICATIONS
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO
USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
ATTENTION: The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock
to persons.
WARNING: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment.
ATTENTION: POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISES ET POUSSER JUSQU’AU FOND.
Compliance information: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
WARNING: The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. WARNING: The mains plug is used as a disconnect device, the disconnect device shall remain readily operable.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING:
TO PREVENT FIRE OR SHOCK HA
ZARD, DO NOT EXPOSE THIS
UNIT TO RAIN OR MOISTURE.
SURGE PROTECTORS:
It is recommended to use a surge protector for AC connection. Lightning and power surges ARE NOT covered under warranty for this product.
FCC RF Radiation Exposure Statement Caution: To maintain compliance with the FCC’s RF exposure guidelines, place the product at least 20cm from nearby persons. The device must not be co-located or operating in conjunction with any other antenna or transmitter.
IMPORTANT SAFETY INSTRUCTIONS
Some of the following information may not apply to your particular product; however, as with any electronic product, precautions should be observed during handling and use.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or ground-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
ADDITIONAL SAFETY PRECAUTIONS
a. Do not expose this unit or the AC/DC adaptor to dripping or splashing water. Keep
liquid-filled objects, such as vases, away from this unit and AC/AC adaptor. b. To ensure that this unit is completely disconnected, unplug it from the wall. c. Ensure that the AC/DC adaptor is easily accessible.
d. Please note the information printed underneath the unit. e. Batteries should not be exposed to excessive heat such as direct sunshine, fire,
etc. f. Do not impede the ventilation of this unit by covering the ventilation openings with
items such as newspapers, table-cloths, curtains, etc. g. Keep open flames, such as lighted candles, away from this unit. h. Do not place this unit in closed bookcases, racks, or other spaces without proper
ventilation. i. Use only the same or equivalent type batteries as there is a danger of explosion if
the incorrect batteries are used or they are installed incorrectly. j. Dispose of batteries properly according to environmental regulations.
Inside the box
Ci320 Bluetooth Speaker with Clock, AC power adapter and user guide.
AC power source
Insert the small end of the AC adaptor into the DC In Jack (located on the rear of the unit). Connect the other end to a wall outlet providing 100-240V AC, 50/60Hz.
The output of the provided AC/DC Adaptor is DC 5V 2.5A.
Notes: Disconnect both ends of the power cord when not in use. Use only the supplied AC adaptor with the following spec.:
AC In – 100-240V AC, 50/60Hz / DC Out – 5V 2.5A
Backup battery
To keep accurate time, this unit uses (2) “AAA batteries” (sold separately) for clock backup. These batteries keep the clock operating in the event of a power interruption.
Backup battery installation
1. Open the battery door by pushing in on the tabs, then removing the door.
2. Insert two (2) “AAA” batteries following the correct polarity indicated in the battery
compartment.
3. Replace the battery door back on the compartment. Notes: The batteries are used to backup the clock and alarm times when the AC
adaptor is disconnected or there is a power failure. Alkaline batteries are
Loading...
+ 8 hidden pages