Cantek CT-HCVR7108H-V2, CT-HCVR7104H-V2 Quick Start Guide

HDCVI DVR General Mini 1U Series

Quick Start Guide

Version 2.0.0

2

Welcome

1. Loosen the screws of the

upper cover and side panel.

2. Fix four screws in the HDD

(Turn just three rounds).

3. Place the HDD in accordance with
the four holes in the bottom.

Thank you for purchasing our DVR!
This quick start guide will help you become familiar with our DVR in a very short time.
Before installation and operation, please read the following safeguard and warning carefully!

Important Safeguard and Warning

 All installation and operation here should conform to your local electrical safety codes.
 We assume no liability or responsibility for all the fires or electrical shock caused by

improper handling or installation.

 We are not liable for any problems caused by unauthorized modifications or attempted repair.
 Improper battery use may result in fire, explosion, or personal injury!
 When replace the battery, please make sure you are using the same model!

Note: All the installation and operations here should conform to your local
electric safety rules.

1. Check Unpacked DVR

When you receive the DVR from the forwarding agent, please check whether there is any visible
damage. The protective materials used for the package of the DVR can protect most accidental
clashes during transportation. Then you can open the box to check the accessories.
Please check the items in accordance with the list on the warranty card (Remote control is
optional). Finally you can remove the protective film of the DVR.

2. About Front Panel and Rear Panel

For detailed information of the function keys in the front panel and the ports in the rear panel,
please refer to the User’s Manual included in the resource CD.
The model in the front panel is very important; please check according to your purchase order.
The label in the rear panel is very important too. Usually we need you to represent the serial
number when we provide the service after sales.

3. HDD Installation

This series DVR has only one SATA HDD. Please use HDD of 7200rpm or higher.
You can refer to the User’s Manual for recommended HDD brand.
Please follow the instructions below to install hard disk.

3

Name

Icon

Function

Power button

Power button, press this button for three seconds to boot up
or shut down DVR.

Up
Down

、

Activate current control, modify setup, and then move up
and down.

Increase/decrease numeral.

4. Turn the device upside down
and then turn the screws in
firmly.

5. Fix the HDD firmly.

6. Connect the HDD cable and
power cable.

7. Put the cover in accordance
with the clip and then place the
upper cover back.

8. Secure the screws in the
rear panel and the side panel.

Note:

 You can connect the HDD data cable and the power cable first and then fix the HDD in the

device.

 Please pay attention to the front cover. It adopts the vertical sliding design. You need to

push the clip first and then put down.

4. Front Panel

The front panel is shown as in Figure 1.

Figure 1

Please refer to the following sheet for front panel button information.