Canplas 3910PA15 User Manual

CANPLAS® PLUMBING SOLUTION

Plaster Trap

Plaster Trap

The Endura

Plaster Trap is

Installed on

a wide range of

FEATURES

• Durable polyproplylene construction

• Inlet connection made with with
1” x 2” MJ adapter (not included)

• Easy access and maintenance

• 440 lbs load rated cover, suitable for
both in-oor and on-oor installations

• Maximum continuous operating
temperature of 220 F

applications

where by gravity, ne material is

required to be separated from the waste

water ow. This includes materials

such as plaster, clay, sand, sediment,

grit and general debris. Any material

heavier than water can be successfully

separated in the Endura Plaster Trap.

,

• Removable outlet lter

• 10 GPM and 20 GPM ow rate solutions

www.canplasplumbing.com

Plaster Trap

Plaster Trap

This unit is designed for use with inlet waste connections up to 1½” diameter the inlet connection being made with a
exible no-hub coupling (not supplied). Based on the outside diameter of the inlet/outlet these ttings will need to be
either 2” x 1 ½” or 2” x 1 ¼” reducing style couplings and are available from most plumbing wholesalers or DIY outlets.

DO NOT decrease the pipe diameter across the unit – i.e. inlet vs. outlet. Please Note : The Endura Plaster Trap is

made of polypropylene which will not accept solvent weld cement.

Based on the use of 1½” pipe the maximum ow rate that can enter and pass through this unit is 20GPM.
Unlike a grease interceptor no ow control device is necessary in this application.

Tank Dimensions

3910PA15

A 14.5”

(368mm)

B 17.5”

(444mm)

C 3.5”

(89mm)

D 12.8”

(325mm)

E 16.3”

(414mm)

3920PA15

A 23.6”

(600mm)

B 17.5”

(151mm)

C 3.5”

(89mm)

D 12.8”

(325mm)

E 16.3”

(414mm)

Servicing & Maintenance

Your Endura Plaster Trap will require periodic servicing to
remove accumulated material and maximize its ongoing
eectiveness. This process can be achieved manually by
bailing out excess water, collecting accumulated debris to
a suitable container by hand for disposal/re-use, or
using a suitable wet vacuum extraction unit. Alternatively
a contractor can be usually found locally who can use an
industrial vacuum method to remove and dispose of the
entire contents on a regular basis.

Canplas Industries Ltd.

P.O. Box 1800, 500 Veterans Drive
Barrie, Ontario, Canada L4M 4V3
Tel: [phone]

Toll Free: 1-800-461-5300

GD-01030-04-12 PRINTED IN CANADA

Fax: [phone]

Ensure that you check the outlet screen during this
process and clean the lter mesh accordingly. It will be
necessary to check the operation of the Plaster Trap on a
weekly basis for the rst 6-8 weeks following
commissioning. This will allow you to assess the on going
schedule of maintenance.

Canplas LLC

11402 East 53rd Ave.
Suite 200, Denver, CO, U.S.A. 80239
Tel: [phone]

Toll Free: 1-888-461-5307

Fax: [phone]