Conversation Table
Assembly Instructions
Step 1
Lay the table top upside down on a soft surface, taking care not
to scratch the top. Insert the threaded metal posts (6) into the
threaded holes on the underside of the table top with the hex
hole facing up. Do not tighten, as this could force the post
through the table top.
Step 3
Step 4
Step 2
Slide the table legs over the metal posts and then
attach the washer/nut combination to the posts. Hand
tighten only.
Note: While the product can be assembled by one
person, a second set of hands will help considerably.
Parts List
Table
Table top
A.
Table legs
B.
Circle brace
C.
Hardware
1" Threaded posts
Nuts
Washers
1
3
1
9
9
9
Insert the threaded metal posts (3) into the
holes of the circle brace as shown. Snug them
up with the supplied hex wrench, then back
them back 1 turn
With the table and legs still upside down, attach the circle brace
to the tabs on the legs as shown. Snug tight with a 9/16"
wrench.
When all nuts and washers have been hand tightened,
tighten all nuts with a 9/16" wrench.
Alternate until all are tight.
Loading...